Find a professional gate installation in South Adelaide

Heavy cast iron side gate that needs to be remounted to brick archway. Would need new hinges to open easily.

Motor broken. New motor supply and installation needed. Please make your offer

An old side gate no longer works and needs to be replaced. Preferably want a "good neighbour fence" style side gate installed to replace the current gate. Current gate measures 1780 X 790

We are needing two new side gates built. We are looking for the existing ones to be dismantled and replaced with new powder coated frame with powder coated slats. Thank you.

Need a 8m strip footing (8000mm x 300mm x 130mm deep) for electric sliding gate. All materials and equipment to be supplied by worker. Can provide timber for boxing if needed. Will be 4m at 300mm across driveway graded as Gravel driveway and then 4m at 220mm and a small pad for gate motor.

Gate latch replaced, new kitchen cabinet handles installed

The highlighted "rivet" or screw is loose and almost out of the D-latch mechanism. Not sure if it can be repaired or if it needs to be replaced . If replaced it would need to be in black.

Install the colorbond fence gate in LHS of the property with lock latch ( monument colour ) Side is 900mm wide and height 1800mm

I need a side gate for my newly built house, just something basic that matches either the fence or the white render out the front.

Electric Gate needs wooden panels re-cladding, painting and maybe waterproofing. The steel frame is in great condition however four of the wooden panels have come loose and definitely need replacing. The others might need to be looked at to ensure they are not going to go the same way. They will also need painting so that there is no water Ingres. This might require a fitting on the top of the gate to direct water away from the panels below.

The location of the gate is currently good neighbour fencing. Requires ‘shorting’ of the fence, concreting fence post and installing gate. Perhaps easier to explain via phone conversion.

I need 3 gates and a small fence to cover the areas in the photos

I have an automatic entry gate. The wood has warped and come off the frame on the outside. It needs fixing & replacing.

Install a Stratco quickscreen side gate (1100mmW) wide and adjoining panel (600mmW) fixed into the concrete paths.

Exisiting lock on side gate is no longer working. I have a new lock to be fitted in it’s place

Automatic sliding door has become stuck and manual lever handle is also broken, just need to open the gate manually.

Re fix gate by drilling into cement and side of house

Garden gate does not align and latch is hard to close and secure

We have a makeshift fence which was used for keeping chickens out of the carport. We now have a puppy and need it replaced with a permanent dogproof fence and gate. Acacia steel panels preferred. Needs to have base of fence run under the ground to prevent digging under. We have a new lawn, digging needs to be minimal. Photos of the area attached. Fence length is about 9m.

Gate is touching the ground. Unable to open with the remote. Sliding gate