Find a professional gate installation in Munno Para

Looking for someone experienced with retaining wall drainage to install an AG drain behind an existing retaining wall/fence line. Scope of works: * Pull down fence panels and reinstall * Approx. 20 metres of drainage run. * AG drain pipe supplied (100mm slotted pipe with geotextile sock already fitted). * Approx. 1.5 tonnes of screenings supplied on site. * Lay AG pipe with appropriate fall to discharge point. * Install screenings around and above pipe. * Check drainage setup is suitable for retaining wall use. * Minor trench tidy-up and final cleanup on completion. Site conditions: * Most trenching has already been completed. * Narrow access in some sections. * Photos attached. Please quote: * Labour only. * Any additional materials required. * Estimated time to complete. * Experience with retaining wall drainage and AG drains.

Quote to finish welding 1/2 gate and then weld the 2 halves together. Fit motor drive bar to gate. Install motor and run power to power supply. Need a quote to do that and a separate quote to supply the mq DC DC DC ootor, drive bar, track, stops and guide rollers. Quote to finish installing gate and everything else to get it fully operational.

The pool gate needs a spring mechanism to close the gate.

Need a concrete plinth finished off for a 5.5m long rolling gate. The finished height of the plinth and level is fairly critical. Most of the trench is dug out already. I had marked out the finished height along the trench. Possibly need some Rio bar supplied. The far side of the driveway is basically the level for the plinth to finish at but the near side of the driveway needs to either be professionally ground or the plan was to cut and chisel out a small part 80mm wide and 30mm deep at the highest point. It wasnt much overall. Experience with this type of work essential. We have a number of bags of concrete and some rapid set if they can be mixed together. I will try to get some more photos to post but probably easier if your local to come past and have a look. Open to quotes just had to put a figure in.

We are building in wellington east and need 2 x 3mx3m gates supplied and installed either side of the house . Needing quotes.

I have a side pedestrian gate which I need moved back towards the street. It should be able to be fixed to the fence in the same way just further down the path. I just need 1 room of the house behind the gate Unsure of price so if I have low balled, I apologise

Hey everyone I got someone doing it for me! Please don’t send an offer

Looking for an experienced tradesperson (builder/handyman) to help enclose part of my pergola. I want to install white/translucent corrugated or polycarbonate wall sheeting (like shown in the photos) along the upper section to block weather while still letting light through. Scope of work: • Supply and/or install white translucent sheeting (similar to photos) • Fix sheeting securely to existing pergola frame (metal frame) • Cut to size and fit neatly around posts and edges • Ensure it’s weatherproof and well sealed • Maintain airflow and keep lower section/opening accessible (cannot fully block entrance) Details: • Location: Blakes Crossing • Pergola already built (see photos) • Only enclosing upper sections, not full wall • Happy for you to come out and quote properly Important: This task price is for a quote only. I’m more than happy to proceed with the job immediately if you have a solid solution to enclose the space. Payment will be made upfront once the quote is agreed. Requirements: • Experience with pergolas, patios or outdoor enclosures • Own tools required • Clean, neat finish expected Please only respond if you’ve done similar work before — photos of past work are a bonus.

We have a small gate that needs to be installed down the side of the house 1.5 mtre high by approximately 1.5 wide.! Will need to put two new uprights in first . 2x 2 mtr galv square posts , quick set concrete and all hardware ready to go. My father is elderly and can no longer do this sort of thing :(

Install motor quote on existing fence

Job 1: Bathroom bathtub tap is leaking/dripping and requires a washer replacement. Tap needs to be opened, worn washer replaced, reassembled, and tested to stop leakage. Job 2: Side gate lock is faulty/damaged and needs to be removed and replaced with a new lock. Gate must be secured properly and lock should operate smoothly.

Hi, I would like to get this gate changed into a sliding gate. Job will require some cement slab as well. Looking for a quote for complete job. $350 is just an indicative cost, happy for you to quote what is reasonable and we can work this through. Thank you

Gate Repair Scope of Works - De-cladding: Removal of Colorbond sheets to access the internal frame. - Structural Adjustment: Removing existing frame screws, squaring the metal frames to remove the sag, and re-securing the joints with new heavy-duty metal screws. - Apply protective anti-rust coating to the frame - Re-cladding: Re-installing Colorbond sheets onto the now-level frames. - Hardware: Re-fitting existing hinges and sliding bolt to ensure smooth operation. Quote Offer - Fee: attached to airtasker quote - Duration: approx 4 hours Inclusions: All travel, labor, tax, and Airtasker fees. Locking Options: - Standard: Re-use your existing sliding bolt for no additional charge. - Upgrade: I can supply and install a more user-friendly latch (like a D-latch or gravity latch) for a small additional fee once we confirm the part you prefer.

Install latches Attach the loosen gutter pipes with the wall Fix a crack on the patio roof

Our side gate has a broken hinge thingy and we need it reattached, let me know if you need more phots or information.

I need someone to fix my front gate. The lock area is not align and doesn’t line up properly anymore, so the gate won’t close or lock properly and there a little gap.

Looking for someone who can repair a sliding automatic main gate. Main gate motor is not working so need to replace motor.

Supply and install or just install price i can buy the unit

I need a good neighbour side gate approx, 990mm plus installation

Side gate will not shut properly, needs to be slammed to shut. Gas meter box will not latch. Needing both to be repaired. No idea the problem, can negotiate appropriate amount.