Find a local floorboard profesional in Manly NSW

We’re looking for someone experienced with Millboard decking to extend an existing Millboard step from approximately 170cm wide to 430cm wide - in the same design material and colour and similar depth and including framework, materials etc.

Need to install new skirting boards. 9.3m run. Needs to matching existing boards in place

High quality required: Need a couple of rooms sanded in federation house (old floorboards, and in kitchen new floorboards) Downstairs - Room 1 4x4m Kitchen 4.6 x 5m 18 Stairs 0.24 x 0.8m Floor upstairs 11 x 1.6m Bedroom 1 upstairs 4.1 x 3.9m Bed 2 - 2.6 x 3.5m Bed 3 - 2.7 x 3.7m Living room upstairs 6 x4m After sanding, floors need be oel’ed and whitewashed.

Electrical wiring has been very badly installed behind skirting board . https://www.archiprofiles.com.au/products.php?cat_id=6&subcat_id=10 Skirting board needs to be replaced with grooved skirting board that will allow wiring to run through skirting boards - Due date: Flexible

We have NSW spotted gum floating floorboards and they have been damaged by moisture. The small section near the sliding door is water damaged most likely caused by moisture trapped underneath a floor mat. We have the Quickstep spare timber here on site (one and a half packets) but we don't have any spare underlay. The skirting may need to be removed and put back. The affected area is not large and the repair will be limited to one and a half packets of timber. - Due date: Flexible