Find a local electronics repairer in North East Melbourne

Tiles and the wooden foundations fixed and level. New skirts for the wall.

2 taps are leaking and I need a shower head replaced

I have 3 new Pool Pumps needing to be installed And old ones removed And also needing advice on a new filter system … And we need to install a new solar controller as old one died Thanks

Change the tap in the kitchen to a retractable dual spray mixer. Change 2 bathroom taps and mixers. (3 sets) Change the bath sets. All have been purchased.

Please remove tree and four stumps. Access is quite limited due to pool area. Would prefer the stumps removed entirely if possible, otherwise quote to have them cut as low to the ground. The last photos show access.

Dig out 2 x small tree stumps 2 x small shrubs with root system 1 x medium tree stump with small amount of green foliage Dispose of in my green waste bin.

Need someone fix my ps5 hdmi port with resalable price

2015 PXII 3.2 litre Ford Ranger Had racv out to jump start my ute. Battery charging at 12.3 Volts. Once jumper leads taken off car stopped. Possible alternator Price to supply and fit

Hello Needing someone to move one of our taps as we’re putting a shed. The other tap we have it is quiet low if we can move this higher Thank you

Fix 2 taps which are shaky 1. Washbasin tap (this might need moving the basin and do it or even put a new one (I will have a new tap stand by)- see pics ) 2. Sink tap - this might be an easy one - It just keep shaking even after I fix it with my hand. So just need a good fix so that it doesn’t keep shaking

Needs to paint a patch on a wall that has been painted but with a wrong white paint. Need to paint that and few touch ups trough out the apartment for a rental property.

There was a hedge that has been removed, but the stumps are still in place and need to be ground down. There are seven small stumps in total. Stumps with small limbs will be cut back so only the stump remains for removal. When: Needs to be completed before Monday.

Trim Laminate benchtops, one sink cutout and join prep for two straight corners (routing recesses) required. Trimming - There are 3 benchtops 1. Trim 246 cm benchtop to 240 cm and cut sink opening. 2. Trim another 246 cm benchtop into two sections (~75 cm and ~130 cm). 3. Trim a few cms either side of 240 cm benchtop (cut a few cm off each end to remove damage sustained in transit). Cut one sink opening Prep straight corners - router underside recesses for connector bolts. Please quote price - also happy for you to quote second quote for install onto cabinets - existing cabinets - all level.

My gas hot water system Dux Prodigy ignition/pilot light keeps turning off and won’t stay lit. I managed to follow instructions and the flame stayed on for 2hrs and now the flame won't light up when following the instructions.

We want two new taps installed outdoors. One at ground level near existing pipes and one almost directly above this on the upstairs deck. Pics of existing supply and approximate placement of taps desired. We can provide the actual taps only, but not the pipe or anything else that might be needed.

Replace two taps in the kitchen with two pull-out taps. Images attached for reference. Must be licensed plumber.

Need an experienced handyman or plumber to fix leak/drip in 4 spindle taps: • 2 basin taps (hot & cold) • 2 shower taps (hot & cold) • All taps are the spindle type and currently leaking. Requirements: • Supply suitable washers ( for spindle taps) • Bring your own tools • Ensure taps are reassembled correctly and not leaking

Need a paint and plaster work touch ups for a property in Donnybrook. Photos attached for your reference.

These two taps are the most used taps in the house and leak especially during the winters. They used to drip and now have started to flow in a tiny stream even when the tap is closed and shut very tight. The house was built in around 2005. We will prefer to work with someone with registered plumbing experience.

My bathroom tap has been leaking for a while. Tried to change them myself but the taps underneath are so frayed I couldn’t get the spanner to undo it so some other tool is needed. Will buy the taps just need someone to do the job. Toilet is also running water and mini stop isn’t working to close off the water. Will be buying a new cistern so need that replaced as well as the mini stop.