Find local NBN electricians in NSW

Want to move nbn connection to directly underneath the house so it is out of site. Right underneath where it currently is is a storage unit that is easy to access - it can be moved in to there

Description: I need an electrician or registered data cabler to assist with part of my NBN FTTC to FTTP upgrade. The job is to run a fibre cable (Prysmian SC/APC to SC/APC, 30 m) from the external NBN wall box to the internal location where the existing sockets are. The cable needs to be run under the house. Access is available but it is not completely clear or stand-up height. The NBN team identified this route previously but will not complete it due to current policy restrictions. The fibre should enter the house at the internal wall near the existing socket panel. It is important that this is done neatly with no damage to floors or walls, and that all entry points are properly sealed so there are no gaps or holes that could allow insects or drafts. A blank faceplate to be fitted, prior to NBN fitting their own kit in its place. A clean, professional finish at the faceplate is important. Approximately 0.5 m of fibre needs to be left inside the house (behind the faceplate at this point for the NBN technicians. There is an existing copper cable that was run through the same route by NBN around two years ago. Photos and a floor plan are attached. The red line shows the intended cable route from the external NBN box to the internal location. Expected to be a short job (around 1 hour) for someone familiar with NBN FTTP prep work. Requirements: • Must have prior experience with NBN fibre installs or FTTP preparation work • Electrician or registered data cabler • Careful internal entry with no major damage to floors or walls, apart from hole covered by faceplate. • Blank faceplate is required (important) • Test fibre continuity after installation

Need a certified technician to install an RJ11/NBN wall socket for internet access. The apartment only has an old 600-series telephone terminal. There is no modern RJ11 or NBN-ready socket installed.

We have just moved to Nashua and in need of someone to help connect our Wifi with Telstra, please (UniFi modem). Would love to have this completed today or tomorrow please. Thank you!

Nbn access point in bedroom Move to living room or install extend ethernet cable to living room.

Looking to move my security system NBN box through the room right next door

I need the nbn fiber conduit on side wall of my house rerouted as shown in attachment. Existing length is ~9 meter

I’ve noticed multiple ethernet wall ports around the house and would love to have my NBN connected this way to avoid wifi issues. I have tried myself but can’t seem to figure it out

The wall socket our modem plugs into is old and is not connecting. Want to replace with the Ethernet wall fixture.

Requesting a quote for Eufy S4 max NVR 4 x dual camera installation and NBN box movement from living room to study nook.

Unfortunately our puppy ate our NBN cable 😅 would love someone to come fix/replace it. If you offer to also install puppy proofing cover on the new cable, would love that too!

My Airbnb guests say the wifi is “not working”. I can’t be more specific , sorry. They have turned the modem off, then on again. I’ve checked and there are no NBN outages, nor service provider outages. I’d like to add cables one direct to the NBN outlet (to eliminate wifi problems) and one to the aerial (so free to air broadcast TV is available)

I recently got a Mate NBN subscription and received my Wi-Fi router. NBN technicians installed the black Arris box in my garage, but I’d prefer to have the router set up in the living room. Need someone to: • Check if the living room coax outlet works • Connect everything correctly • Make sure the internet is online and Wi-Fi works Haven’t bought any extra cables or adapters yet — please bring what’s needed. Located in Collaroy Plateau. Should be a quick job for someone familiar with NBN setups.

iQ5 box and peripherals with remote LG 48" smart TV Bose Wave Sound system & remote Samsung Sound box All need setting up and interconnected. In living room. NBN connection in situ. Needs to be done Friday 26/09 anytime/ or Sat 27/09 before 2pm.

I have a long NBN cable running along my hall that I would like hidden as much as possible. Perhaps nailed to the wall and painted or put under the floor boards.

We moved house recently and had no wifi this week. We have a new provider and new nbn box and nothing is connecting we need help

I need NBN Cable Coax terminated in the office. The previous tenant ran the cable some where else.

We are a warehouse - just got NBN connected to the warehouse. We need a parky to connect the NBN cable to the existing module so we can access NBN from exisiting ports in the office.

We want to bring NBN power up off the floor and more flush to the wall. I have checked under house and plenty of slack. Minor wall work needed which will be covered by a sideboard.

Hey i need a registered cabler to change my nbn socket location (which is currently upstairs) to ground floor. i have a nbn socket on ground floor and needs to be activated