Find a trusted local light installation service in NSW

I need an Electrician or handy man to help install a pendant light fitting at 4.5m from FFL. A-frame ladder will be required. Pendant weight is roughly 8kg. My partner will be available to assist with the install (also an Electrician).

Hello, Note: I have reposted this request as I was having issues with previous task. I hope that is okay. Please provide a budget-friendly fixed quote to install 4 ceiling fans with timber support, replacing existing light fixtures at Blacktown 2148 (single-storey house). Remote controls to be wall-mounted, existing power switch connected to each fan, and site cleaned after completion. Thank you,

Need 2 Outdoor Lights installed. One sensor light at the front and one designer light. Both Hardwired, but wires already present. The light just needs to be fixed and tested. Also need one Light point checked in the Backyard.

Installation and supply of LED lights around 4x display board in showroom Must be licensed Elecrician

Down lights and Plugbase will be supplied by myself Townhouse has 6 existing old down lights that will need to be swapped to new ones Approximately 14 new holes for additional new down lights Wiring to be supplied by installer. Only licensed installers please. All install is ground floor of 2 level town house.

need to replace my living room’s pendent light with new light It’s 5.8 meters high and you need to have either long ladder or scaffold

Backyard with 6 Lillypilli trees

Business in tweed heads south. Need down lights installed. Currently have flurecent lights. Around 12 Already have lights .

Hi mate, I need to replace two ceiling lights. They are currently round LED flush-mount ceiling lights, each about 30 cm × 30 cm. I would like to change them to: one pendant light, and one flush-mount light with a bulb and lampshade. For the pendant light, the ceiling junction box (the small box where it connects to the ceiling) is only about 10 cm in diameter, so I think the ceiling hole will need to be patched. The ceiling is white. I don’t mind if there is a slight difference in the white paint colour, but it would be great if you could provide the paint needed for the patching. Thanks!

Looking to have two new hanging light pendants installed within the kitchen. Holes will be moved slightly. Have lights ready to go

After an electrician to install a fan and light combo in our unit - 3 in total, lounge room, and 2 bedrooms. (due to being a unit and no access to roof it will need to be remote controlled) have a fan and light we would like to order but would like confirmation prior to ordering Happy to take quotes. Thank you.

install skylight on single story corrugated tin roof Ceiling is made from wood Skylight already purchased. Measurements are in the photos of the skylight I need an installer who can form the well and finish it off neatly. The pitch is low -15% or less. I want the installer to come to my home and see the job in person. I am in Newtown. Please don't contact me if you can't do the whole job ( carpentry part and maybe gyprock)

I have a few lights to be installed

Install the new LED lights in the sauna.

We have three ceiling fans/lights we need installed in three bedrooms. Each spot where the fan is to be installed will replace where a current downlight/ceiling light is located.

Remove old light and install new light

Install Pendant Spatial light. 6.5kg Its on the stairs. 3.3m to step. The wiring is prepped already

Hi! I’m looking for a licensed electrician to: Install 2 x dimmable fan lights (bedroom and living) - replacing current dimmable lights. Change out the grey and black PowerPoints for all white. As pictured, I have some parts such as the fan light. I have some PowerPoints already but could find others. The ones pictured with the changeover part are good to go. The grey and black pictured on their own would need a part found - hoping you can help source. I live on the ground floor of a unit complex. Thanks!

Hi, I’m looking for a licensed electrician to install LED downlight points and LED strip light points at my home. Single Story house, 90mm cutout. Details: • 10x LED downlights will be provided – need installation and connection to existing switches. • All lights and fittings will be supplied. • Need someone who can complete the job urgently (preferably within tomm) Requirements: • Must be a licensed electrician (please provide license number). • Bring necessary tools and materials for installation (cables, connectors, etc., if required). • Ensure neat and safe electrical work. Location: North Kellyville Date: Friday, Oct 16 2026 Budget: $500 or “Open to offers”

1) Need to install lights in the bathroom. 2) Fan is not working. Need to check