Find local power point installers in Sydney Eastern Suburbs

I would like a qualified electrician to install and conceal an extra power point on my balcony. It would run from an internal power point to the balcony with the wires concealed. Also to replace my existing fused led light strip (X3)in kitchen.

Screw in 3 light switches 1 power point 1 light

I need someone to re-secure an existing power point that has come loose from the wall in Bellevue Hill. The fitting is not to be replaced - it just needs to be safely reattached and the wall area tidied up so it looks neat and secure again.

Looking for a licensed electrician to fix electrical fittings after an internal wall demolition. I need the following reinstalled and connected: Refix 2 power points. Refix 1 light switch. Test the circuit and confirm everything is working correctly. Ensure all work is compliant and provide a Certificate of Compliance if required. The wall is already open, so all wiring is exposed and easily accessible. No wall chasing or demolition is required. Located in Bondi Junction. Please quote including labour and any minor materials required. Licensed electricians only.

I need a licenced electrician to move power point 10 cm to the left on a Gyprock wall, another removed from the skirting of a built in wardrobe and two landline phone points removed. Photos in order below.

remove dimmer from a 2 gang switch plate with 2 switch only. Check one power point that is not working install an outdoor power point outside back door The address bounces to Watsons Bay the right address is Woollahra

Hi, I need a licensed electrician to safely disconnect a double power point (GPO) located in a bedroom and replace it with a flush blank cover plate (you to provide this).

I need a 3 sets of electrical cables terminated in one bedroom. One set is for a power point, the other is an aerial outlet and the third is a CBUS control point that we no longer use.

I need 2 power points fixed. One of them you can’t put a plug in one of the sockets, and the other one you can’t put a plug in one of the sockets and the other socket the switch won’t move. I also have 2 taped off wirings that needs to be removed.

I need a power point put in in my hallway! There is one on the other side of the wall so it should just be a matter of connecting through to that one

I need to wire a power point in the up stairs of my loft apartment. Cables already ran, just need a multimeter. Easy job.

I need a qualified electrician to supply and fit 5 double power points to spots around 4 walls from existing power points. New power points to be surface mounted (screwed into brickwork), connected by 2.5 mm twin and earth cable installed in surface mounted 25mm X 15mm ducting double sided taped to wall. Approx. ducting length = 20 L Meters. I need a certificate for an existing smoke alarm also.

Electrician Required – Small Residential Jobs Looking for a licensed electrician to complete a few small jobs at my home: Bathroom wall switch repair – The single gang switch controls both the exhaust fan and the lights. Currently, only the exhaust fan turns on; the lights are not working. Downlight not working – One downlight won’t turn on. I’ve already replaced the LED globe, but it’s still not working. Replace double power point – The internal white plastic insert is old and needs replacing. The existing cover plate is in good condition and can be reused. Please bring any necessary tools and parts. Flexible with timing. Thanks!

Smart toilet wiring including the new power point installation into the existing tiles wall.

As advertised, I have bought a Caroma Smart toilet which required the electricity connected. There is a ceiling opening as shown photo 2, but it is painted over. Nearby there is a ceiling fan shown photo3.

I have already written in the the original ad.

I am replacing an old toilet with a smart toilet. It requires a new power point and wiring. The wall is tiled and no replacement tiles are available. I need a qualified, licensed and experienced electrician for this job.

Install missing power point to wall

To remove the old power point and install the new.

I need to run a connection from the living room space to two locations with ethernet jacks. 1 port one floor up directly above the living room. Another one 5 rooms away. Both cable runs could go long the outside of the house if in wall/roof or floor cabling is difficult. (If networking is your thing, you could connect a basic mesh system or ubiquity but I'm happy for just the cable and wall plugs to be installed. The house is brick. I'd also like a powerpoint installed directly opposite a powerpoint on the other side of a brick wall.