Find a sockets and switches installation professional in NSW

Replace total of 28 switch and socketfrom old to new

The power sockets in half of the house stopped working after the blackout on Friday, need someone to fix the problem. I have to run extension cables to run fridge and other appliances in that half of the house. Checked the trip switches on the board and they seem to be working and no signs of fire or short circuit or any smell .

Will require on-site quote hence the low price. Re-post so I can get multiple quotes Replace 8x old light fittings new new LED fittings Replace 8x old light fittings with new ones Replace 4x old power points with new ones Concrete walls & concreate ceilings Will need site inspection prior to doing works Aiming for install next week and quote/scope this week

The light switch mechanism seems broken and can't go to the on position, so we can't turn on the lights in the bathroom. There are two socket switches that also don't go to the on position, so we can't use them.

Three separate electrical jobs - moving one intercom slightly to the left, installing (replacing) four new ceiling lights purchased from ikea, replacing approx 7 light switches and power points with newer looking models.

My lights switches in my house are a bit old, so I am looking to replace them. I will purchase the switches themselves, I just need them fitted. Flexible on timings.

install: 4 sockets in kitchen

Looking for someone who can program wifi light switches, they are all wired and installed.

I have shown photos the light bulb socket is broken and does not hold the light bulb in place and in one photo I have shown the wires hanging out need them all fixed

we need someone to come fix our wall sockets (6) for some reason they’ve all become loose in the house. also we have some ceiling lights (6) that need to be changed. Prices slightly negotiable depending on costs etc. (i will need receipts for purchase if needed)

Electrician required to do a one-room make-good and then come back to fit under bench lighting. we are doing a one room office fit out, there’s lots of stuff on the wall, which I’m not sure what is what or if if there’s any power to any of it, so I need it to all be cleaned up, ready to be patched and repaired. then once we fit out the office I need them to come back and fit under bench lighting.

Hello, We need some help connecting the telephone sockets in the house. This (hopefully!) should be a quick job. We currently have one socket in the house that works. We have sockets in other rooms in the house, but they don't work. We would like to move our modem router to a different room in the house, but need the telephone socket in that room to work. Please see attached photo of the current telephone box.

I am after an electrician that can assist with swapping out existing wall switches (old Clipsal slimline) and plugs with the new icon Clipsal. The existing frame in the gyprock walls fits the new switches. Switches are supplied. I also need four pendant lights replaced, existing wiring and pendants supplied. There are 28 Lights switches with varying gangs and 49 Power-Points throughout the house. It also seems that a a number of transformers for the down lights are either loose or out. I’d say there’s a about 6 of these. I would appreciate someone also checking if these can be fixed or need replacing. If you have the knowledge and ability to also check out /reset an Ness Security alarm (no pin or information provided by vendor) that would also be terrific.

Hello, two part task: ADD NEW SWITCH Currently the lights for our room are controlled by a master switch outside. We would like to have our own switch in the room separate from the master switch. Will require a light switch for the room. PHILIPS HUE LIGHT INSTALL I need four light sockets installed and these Philips Hue downlights put into my depression treatment clinic in Edgecliff. Here are the Philips Hue lights, I am unsure of additional materials required: https://www.jbhifi.com.au/products/philips-hue-colour-ambiance-bluetooth-downlight-90mm And I have included a picture of the clinic attached. They are for one room and the roof is made from the panelling you see in most older office buildings. Once set up, we would like to take out the fluorescent bulbs and have the downlights act as lighting for the room. Ideally we could cover up the fluorescent bulbs with roof tiles of which there are spares. There is only one switch to control the fluoroscent lights for the whole clinic but we want to be able to dim lights for our treatment. Unsure about hourly rate but happy to talk about what is fair. Josh - Due date: Tomorrow or Monday 19th of Feb

We need two light/fan/heat switches in both bathrooms replaced. The switches are provided. One is 4 in 1 the other 5 in 1. - Due date: Flexible

Check existing outlets (approximately 12) and fix the ones which aren't working. And install an additional one. - Due date: Before Friday, 2 February 2024

I need a ceiling oyster light removed and pendant light installed. Also move wall socket plug (if possible) - Due date: Before Wednesday, 31 January 2024

Fix: 1 x external power point (cap snapped off). Need to check that there is no damage due to being exposed to rain. 3 x internal switches that do not flick on right. They are crooked. 1 x external light fitting that does not work. - Due date: Flexible

I require a licenced electrian to install a dual power socket in my garage for an electric garage door motor. You will need to bring the socket, cabling and any ducting as it will be mounted on brickwork and the cable run down from the roof by approx 1meter. Install any time between Jan 3rd to Jan 16. - Due date: Before Tuesday, 16 January 2024

Seeking an electrician to replace approx 12 standard light switches and a powerpoint throughout the house. Just your typical light switches purchased from John R Turk, nothing fancy. Must be a licensed electrician. Thanks - Due date: Needs to be done on Saturday, 23 December 2023