Find a trusted local light installation service in NSW

Pendant light install/remove boob light

Looking for a licensed electrician to install a new pendant light. * Existing light has already been removed. * Mounting bracket and holes are already in place (see photos). * The new pendant light is assembled and ready to install. * Just needs to be wired, mounted securely, and tested to ensure it’s working properly. Please bring any standard tools you may need. Located in Epping, NSW. Looking to have it done as soon as possible. Please send through your quote and availability. Thank you!

I already have a new bathroom. Ceiling fan and light to be installed.

Task: Install 4 oyster ceiling lights Location: St Ives NSW Details:Remove old fittings if requiredInstall 4 new oyster LED lights (already purchased)Ensure all wiring is safely connected and compliantSecure each light properly to the ceilingQuick, clean job—ceiling access is straightforward Prefer a licensed electricianNotes:Please bring necessary toolsFlexible with timing—any day this week worksOutcome: Safe, neat installation of all 4 oyster lights.

Install 3 pendant lights on the island.

I need a fire exit light replaced along with certification.

4 ceiling fan (DC) and 3 light installations. I will provide all the hardwares.

- Install 3x pendant lights over kitchen bench, replacing existing bulb socket - Install 2x lights over bathroom mirror.

I will buy the light fitting and I'd like an electrician to install it on a back verandar of a house in Panania, 2213 NSW

Need pendant lights in dining and kitchen to be installed. Along with other recess LED light strips and other light features in other areas.

Need to install Uniden urf radio and spot lights in my 2025 Triton.

Need a licensed electrician to install 4 LED tube lights instead of the bulb as shown in image . I have supplied all lights. Budget: $100. Please message if available.

Hi, I've had a couple of new lights installed, leaving some marks (and some holes) behind to repair. I have two holes (kitchen and bathroom) that need plastering. Including these two, I have an additional two locations that need some sanding and paint matching to surrounds. Ceilings are about 2.3 to 2.8 m clearance from floor. Let me know if additional measurements needed, please use images for reference. Contractor to supply all materials and labour. I do have some plaster offcuts but will need to source elsewhere. I have unrestricted street parking and basement parking (2.2 m height clearance). My unit it on 1st and 2nd level (bathroom and bedroom on 2nd level, kitchen and dining room on 1st level. To access unit, you need to go up two flight of stairs, and there is a flight of stairs inside to go from 1st to 2nd floor. I am around to assist with carrying gear if needed.

Installation of a wired Google Floodlight Camera. There is an existing power outlet located close to the intended installation position, which I believe can be used as the power source for the camera. The job would involve mounting the camera, connecting it to the power supply, and ensuring it is fully set up and operational. Please let me know if any additional information or photos are required to assess the installation.

I have had two skylights installed on the roof already but need the internal work done to finish the installation. Details are below. Please be clear if your quote does or doesn't include materials and give a materials estimation cost if it doesn't (I understand paying separately for materials is favoured by some AirTaskers): Skylight 1 - skylight tunnel, photo 1 - Velux VSS C04 Solar 550 x 980 on a pitched roof - Require build and painting of approx 300mm shaft depth skylight tunnel to the skylight - Standard rectangle opening, including timber frame and plaster - Ceiling is plasterboard and 2.4m height at low point of pitch as shown in photo. Skylight 2 - ceiling installation, photo 2 - Velux sun tunnel TWF0K14 with flexible shaft - Require installation in flat ceiling, easy access to tunnel via attic - Ceiling is plasterboard and standard 2.4m height

A light needs replacing unable to fit a globe in anymore , another light is damaged only wires needs to be wired up and a unit installed to put in a globe

Supply and install a new office LED light that matches existing lights (see photos). Must be licensed electrician.

I need a pendant light installed in my stairway to replace the current fixture. Will need a ladder to access etc. Photos show the stairs and pendant that we are installing. Simple job for an electrician.

I have a Philips Hue light, looking to install on an exterior wall. (and remove existing spotlight). There will be lots more to do, but let’s start with one!

I need to install downlight in the house and switch boards need to be updated accordingly. There are 4 bedrooms, 1 living area and 1 media room. In total 36 downlight, 7 dimmers, some safety switch upgrades.