Find a professional local car service in North East Melbourne

Change filter and fluid on 1999 Toyota Camry auto sedan. I have filter and fluid here.

Based in northern suburbs of Melbourne. I have a Viofo A229 pro front and rear dash cam with a hard wire kit. I would like it installed on my Audi hatch back hiding the wires neatly in internal panelling where possible.

Hi all, I’m looking for an experienced auto-audio technician to install a full speaker/amp/sub upgrade into my 2014 Jeep Grand Cherokee. I’ve already sourced all the gear — just need a clean, professional install. Equipment to be installed: Hertz MPK 165.3 front components Hertz MPX 165.3 rear coaxials Hertz HCP5D 5-channel amp Focal Flax P25FSE 10” shallow sub Slim sub enclosure Audio wiring kit (RCA, power, ground, speaker wire) Workshop 12 Android head unit (already installed in the car) Scope of works: Install and wire front and rear speakers Mount and wire the HCP5D amplifier Run RCA + remote cable from head unit Run power cable from battery (with proper fuse placement) Install subwoofer and enclosure Set crossovers & gains on the amp Basic tuning to ensure clean, distortion-free output Ensure no rattles, tidy cable management, and proper grounding Vehicle: 2014 Jeep Grand Cherokee WK2 (standard factory audio, no factory amp). What I’m after: Someone experienced with aftermarket head units, 5-channel amps, and sound tuning Clean, professional work (no shortcuts) Someone who can work at my home or I can travel to you (Melbourne area) Ideally available in the next few days Budget: Happy to discuss fair pricing based on experience — looking for solid value and good workmanship. Notes: All gear is near-new, boxed, and ready to install. Happy to help with trim removal/holding panels etc. if needed.

I have a 2013 Holden Cruze 1.8L and require an oil cooler to be replaced. Job is for the supply of the oil cooler, installation and commissioning Qualified mechanics only Quotation required for all works including sundries

I have the disc and pads, just need someone to fit them

I may have filled up an extra half a litre and the system has asked to drain excess oil

Regas 2008 Holden Commodore VE omega sedan air con at my place in reservoir, flexible on dates and time

Routine service of Honda Accord euro 2012 $250 plus $100 electrical system checking

I will provide starter motor just need someone to fit it . only a thirty minute to sixty minute job .

Need help fixing this dent. Can't afford what the body shop is asking for it. Please give me your best, honest offer.

I overfilled the engine oil for my toyota yaris 2010 and concerned turning it on will damage the engine. Just need someone to drain the oil out so I can safely drive it.

I have a LEHX Pro Max Plus head unit with reverse camera that needs to be installed in a Toyota Hiace

Hi Need someone who is good with radio wiring. Need to connect radio which is bought from Aliexpress with mount and retain reverse camera. Location: Donnybrook VIC 3064

I have the reverse camera and head unit already. The head unit is a plug and play android unit from eBay. Looking for someone to install the reversing camera and run the cable. Be competent to take the trims off without breaking them and wire it up (connecting it to the reverse brake light switch) to trigger

I have suitable android screen for my car, it need Installation in 2013 Toyota Prius. The car already have reverse cam but most likely needs to be replaced as the new screens comes with its own. It has all features e.g. use of steering wheel buttons etc, would need someone to do the professional installation. Thanks

Nissan pathfinder 2017 service Through check and repair.

Change stereo in toyota kluger 2010

Reverse camera install on my 2008 Holden VE Omega sedan. I have a external car play screen installed on the top of the dash that I want it to connect to, the reverse camera came with the purchased car play screen in a set and has connecting wires and a mounting frame. If possible want it to record rear video like the front camera built into the car play unit already does.

I have the brake pads and discs I just need someone to fit

Hi, I'm looking for someone experienced to install an aftermarket head unit in my 2009 Mazda CX-9. I was told it would be a simple plug-and-play unit, but unfortunately, that hasn’t been the case. I've also purchased a harness that should allow the factory reverse camera to work with the new head unit. If any additional parts or adapters are needed to complete the job, just let me know and I’m happy to cover those. Ideally looking for someone who has done similar installs before. Let me know your availability and any questions you have!