Find a professional patio contractor in NSW

1. Cutting 3 bedroom Wooden Door Height by 5-8cms 2. Covering Small Patio Area with Corrugated Sheet: - Install corrugated sheets over a small patio area

Wooden gate and latch purchased..gate needs to be cut down to fit opening and posts drilled into patio walls possibly width will work as is but height needs to come down about 10cm to fit under top wall see photos..side posts not purchased two hinges available on gate already

Existing timber patio, requires replacement of some of the timber beams

The cabinet area is 57 cm wood and 86 cm high. It is a vacant space next to the BBQ, in our outdoor undercover patio. There was originally abar fridge in this space. My preference is not to replace the bar fridge there.

We recently renovated and got our patio sliding frame and doors replaced. The fitters took away the frame but were unable to take away the doors (due to company policy). The doors are unable to be collected at council pick up and are too long for our car to take them to the refuse collection point. Looking for someone to take them away. Can provide details of measurements if needed. They are glass with a metal frame.

Need handyman/landscaper to install Stratco outback patio in courtyard 3.8m by 2.4m attached to 3 side walls, no post required. There are 2 existing down pipes, might need divert or cut it out. Height around 2.5m from ground.

A patio with roof , heaters , fans Dimensions: 4.75 m x 4.1m x 3.4m (height)

Install a dog door on sliding patio door. I will need someone to inspect the sliding door and source the right product/dimensions from Bunnings. Will add price of product to cost of labour. Offer of $200 is labour only.

Remove patio sliding doors, framing and sills (for reinstall in another house) and transport about 1.5km. Do not need to reinstall, just deliver

I need a wall pushed back into a cavity, wall removed from kitchen and bathroom access door closed. Patio steps added. This needs on-site inspection and quote done

Need to draw up, design Woodfire oven section with a bench. Brick Base. Design only.

I have a six door timber with glass doors with outside frames to be installed in my patio. Please refer to the attached images. First image shows the doors and the frames, second image displays where they need to be installed.

Installation of patio kit

Installation of Stratco sanctuary patio kit as in image

Need supply and install of Perspex to outdoor patio. 5 panels roughly 1800mm x 160mm each

Needing an outdoor patio/annex installed using eps cool room sanwhich panels. Space roughly 5x4. Materials provided

I’m looking for someone to install sections of drywall or similar on the ceiling to cover the insulation on our outdoor patio. The ceiling is quite low so don’t want to lose too much space, so hoping to have it done in sections between the larger timber beams. Will need to supply the materials too please or let me know what to get. The area is about 3 x 6.7m and there are 11 timber beams, so about 11 sections attached to the existing beams. I will do the painting myself. I have attached a photo of how it was done in our sunroom for reference. Happy for it to be the same or open to other ideas Hoping to have it done in the next week. The sooner the better Thanks

Have had 3 people come around and no quotes back and need it done so our kids don’t jump off the deck anymore. Back deck has a slight sag in one spot. Current deck with no fencing and exposed underneath with open stairs. Hoping to achieve something like the second photo. Thanks!

Licensed handyperson/ Carpenter to build small deck off existing small tiled back patio. Approx 5.5 x 2.5m composite deck. Height off ground way under 1m.

Looking to remove the current sunroom(3mtx3mt) built with colourbond (roof and walls) and wanted to replace it with an Insulated patio along with decking.