Find an experienced driveway repair contractor in NSW

I've just bought a carport (see picture). Ive had it pulled down and shipped to my house this week. I'd like it put back up on my driveway. The driveway is pavers layed on soil and have already had to concrete footings set into into the soil. The airtasker that made the concrete footings didn't realise that he had to level them off before bolting in the posts 😒 Need someone experienced this time to put up the carport please

Objective: Reduce the high spot/apex at the top lip of the driveway to prevent vehicle undercarriages from scraping. Task: Grinding or shaving back a transition ramp across the full width of the driveway. Dimensions: The driveway is 2.5m wide and approx 75cm length of it needs to be ground to a dept of 20-30mm with a smooth taper. Finish: The ground surface must be finished smoothly without sharp lips or jagged aggregate edges. Material: The current surface is exposed aggregate concrete.

I need to grind a bit of my concrete driveway to smooth the angle as it’s rubbing my car

I'm looking for a handy person to install a black Rapidfence steel fence and gate on my concrete driveway in Pymble. All materials are supplied, so I'm after labour only. The fence: L-shaped run, about 7.6m in total 7 × Rapidfence 50 × 50 × 1300mm black steel flanged posts 4 × Rapidfence black steel flat top panels 1 × Rapidfence Balmain galvanised gate, To DO Set out and fix the 7 flanged posts to the concrete drive with galvanised concrete screws (drilling 28 holes into the concrete). Cut the 4 panels to length to fit between the posts. The cut ends need deburring, then a coat gal primer before fitting. Fix the panels to the posts with panel brackets and Tek screws. Hang the gate using pipe saddles top and bottom, so it's level and swings freely. Fit a D latch and a coil spring so the gate self closes & latches. I'm supplying: posts, panels, gate, brackets, concrete screws, Tek screws, D latch, pipe saddles, coil spring, masonry drill bits, and cold gal paint. You'll need to bring: a drop saw or angle grinder with a metal-cutting blade, impact driver, and general tools. I have a hammer drill you can use, or bring your own. It's an existing concrete driveway, so the holes must be kept at least 50mm from the slab edge. Experience cutting and fitting steel fence panels and hanging gates. Public liability insurance preferred. Timing: From Tues 29 Sept onwards. Budget: $500 The total fence length is appox 7.6m. Photos of the driveway and of the materials atached. Task Set out the fence line, then drill and fix the 7 posts plumb and in line (28 holes) 2–2.5 hrs Cut 4 panels, deburr and prime the ends about 1 hr Fit the brackets and panels 1–1.5 hrs Hang the gate, fit the pipe saddles, latch and spring, and adjust 1.5–2 hrs Total about 6–7 hours for one person Finish in one visit if you paint the cut ends first thing, the paint can dry while you fix the posts.

I need a steel rail, installed up my driveway due to the nature of the stairs. Just a simple design is all I require. Approx 12m of rail is required

Hi I would like to have the driveway and in front of the garage concreted Total area 101sqm Please provide quote

Seal driveway and side paths

x 12 Driveway solar lights need to be drilled into concrete down my driveway. Each light require two bolts. Bolts are provided with the lights.

Hi, I need to fix my driveway gate and if possible repaint as well. It has wooden bars but screwed to metal horizontal bars. Few of the bars are broken Attached the picture.

I need to re tile some terracotta tiles in my drive way. It’s just a patch right now

I need help bringing 1 cubic meter of soil from drive way to garden beds in back garden. 3 flights of stairs to tackle Hoping to get it done tomorrow Saturday 15th Aug. Type of gardening: Other Size of garden: Under 50m² Has green waste bin: Yes

Looking for an experienced painter or handyman to fill minor cracks and apply driveway paint to a 20 square metre concrete driveway in Oran Park. What You Will Do - Crack Repair: Clean out any remaining debris from minor surface cracks, apply our flexible concrete crack filler, and scrape it flush with the surface. -Painting: Apply two uniform coats. Tools: Please bring all your own tools (rollers, brushes, extension poles, painter's tape, drop sheets, and crack scraping tools). We will provide the concrete paint and crack filler.

We have what appears to be a blocked sewer line at the bottom of our driveway. Water/sewage is backing up from the drain/inspection point during use. Looking for a licensed plumber to: * Diagnose the blockage. * Clear the sewer line using appropriate equipment (drain snake/auger or jetter if required). * Test that the line is flowing correctly before leaving. * If possible, run a CCTV camera afterwards to identify the cause (please advise if this is an additional cost). Please bring all necessary equipment and include your availability. Photos attached.

Replace colorbond panel to a gate, use removed panel in side fence opening where new driveway will go, install two new posts and adjust fence opening

Wheel barrow loads of wet concrete from concrete truck 5m and dump on driveway Approx 20 loads Less than an hour 9:30am

Looking for someone experienced. Need new drain stored. Must have experience with this.

Driveway is build couple of years back but I require Resealing of it with pebbles concrete finish. Additionally, I also need to complete the garage floor coating. Garage area is 5.5 x 5 meters and drive way is 5.5 x 9 meters.

We have the paint and rollers and tape, but we can't do it, the surface has been prepared and is ready to go, it needs two coats with a two-hour drying time in-between coats the driveway

Need these 2 driveway ramps drilled screwed into the ground. 4-6 screws each. So it stays put

Replace broken concrete edge on driveway. Remove broken concrete/waste, clean out, rebuild edge with new concrete, making smooth & level. Approx. length of damaged area: 1.8 meters