Find skilled builders in South West Perth

Concrete drive way from shed to car port 36 sq m

Concrete drive way from shed to car port 36 square meters

Looking for someone to demolish the front porch area of my house so I can re concrete

Demolition of shed, outdoor roof/pergolas. Demolition of "outhouse". Removal from site of all metal and timber.

Supply and fit Garden shed

I am looking to get a flat pack shed assembled and anchored to a concrete slab (concreting completed by others). Shed EasyShed 3m x 3m x 2.1m Gable. Colourbond.

Cut back overhanging trees from driveway and take green waste away

Replace roof on 3m x 3m pergola

Needing this small shed assembled in my back yard. Open to negotiation

Hello! I need to install the shed - https://www.bunnings.com.au/endurashed-7-5-x-3-75-x-2-48m-tall-garage-garden-shed-rivergum_p0074985

Rebooking task between Camp and Andrea

erect a prefabricated graden shed in the backyard of my property

Assemble my 4.5m x 2.25m EasyShed workshop shed. The shed will be supplied in flat-pack form and includes a portal frame kit. Please ensure the shed is assembled correctly, is square, and the doors open and close properly. No slab or anchoring is required.

Looking for an experienced plumber, reticulation installer, or contractor to install a PVC sleeve/pipe underneath an existing concrete driveway. Scope of Works: ● Bore or tunnel underneath an existing concrete driveway 6m wide (without damaging the driveway). ● Supply and install suitable PVC pipe/sleeve to allow future reticulation pipework to be run through. ● Pipe is required to connect reticulation on one side of the property to the water main on the other side. ● Ensure pipe is installed with sufficient depth and alignment for future reticulation works. ● Backfill and leave the area neat and tidy upon completion. Site Details: ● Residential property. ● Existing concrete driveway is in good condition and must not be cut or damaged. ● Access available to both sides of the driveway. Please provide: ● Your proposed method (directional boring, water boring, manual tunnelling, etc.). ● Relevant experience with similar works. ● Quote including labour, materials, and any equipment required.

INSTALLATION OF FLAT PACK WORKSHOP SHED 4.5 X 3.7

Wanting a pergola put in over the fire pit area. Needs to be braced one end to have anchor points for 2 hanging chairs. Space required is approx 3.3m x 4.8m. Needs to be completed by end of July. Added current photo of area along with some inspo photos from Google. Please advise price - photos of work on you profile appreciated too

Need the shed frame pulled apart and emptied to skip bin. Frame is steel to be cut to the ground. Will need tools to cut it up to size to be stacked or placed in a skip/back of ute. Plus tear down a wooden pergola attached to the side of the house. This requires a team of 2. Should not be more than 3-4 hours for an experienced team.

I require someone to remove all cupboards and remove the floor and wall tiling. Floor is approx 13sqmt, wall tiles is approx 8sqmt. Thisis an apartment on the first floor, there is a stair case next to the door and a walkway to the driveway. You remove all rubbish. I will be onsite to assist with the job as a labourer. No plumbing or electrical work is required. I have reposted the job as I left out it was on the first floor with stairs.

Need yellow sand delivered and fill in excavate section's either side of driveway and crossover to make level ready for paving to be done and dirt pile currently on driveway removed and disposed of Measurements are in hand drawn picture

Assembly of shed, following instructions from supplier. Absco shed ordered through Bunnings. Floor platform will be built beforehand. Need to be assembled against wall.