Find professional window and door services in Baulkham Hills

Replace lever door handle on bedroom door. May require drilling to line up new handle. Looking for help in the evening tonight, tomorrow evening or any time on Tuesday.

The pocket sliding door has sinked to the floor. Sliding is hard and the lock won’t align. The screw needs to be tightened so the door can be lifted but it is not accessible as the door wooden frame is fixed.

Re-hang a sliding door that was knocked of its hinges.

Repair timber door paint and frame and secure lifted carpet

Scheduled door access installation, cost includes materials and labour

I need to replace the back door of my laundary.

Looking for an experienced carpenter or handyman to supply and install a replacement external door and lockset for a side/back entrance.  Scope of Work: 1. Supply Door: Provide a solid core external door (weather-resistant) cut/planed to match existing frame dimensions. 2. Supply Lockset: Provide and install a standard key-operated external entrance lockset. 3. Installation: Hang the new door on existing/new hinges, cut out lock mortise/latch, and ensure smooth closing and latching. Disposal: Take away and dispose of the old rotted door.  Notes & Photos: Photos of the current frame, lock, and bottom water damage are attached.  Hinges are located on the left-hand side.

There is a chipped paint on the bathroom door that needs fixing. Norwest

Fix the glass sliding door of inbuilt wardrobe and mirror in wash screen

Garage door spring re-tension + opener adjustment - Roller garage door with a Boss belt-drive opener. The door reverses when it hits the floor and stalls halfway on the way up. I've done a balance test: with the opener disconnected, the door drops when released at waist height, so the torsion spring has lost tension. Job: - Re-tension the torsion spring, or replace it if it's past it (quote the spring before fitting) - Reset the opener's travel limits and force settings - Test auto-reverse Must have experience with garage door repairs and proper winding bars.

Install Front Screen Door Handle

Unable to open door, The knob rotates by door is stuck and unable to open. It's a metallic door with a glass screen in the main entrance.

The door swung off with the strong winds need to put it back on also need to put a door handle inside on another door

Currently we have 2 single garage doors with a pillar in between. Task is to remove the pillar, restore stability, install 1 double garage door.

Looking for an experienced handyman or electrician to install two Meross Smart Garage Door Openers on my existing Doorworks 1200 motors. Scope of Work: Connect 2-wire signal cables to the existing dry-contact push terminals (WALL SWITCH and COM) on top of both motors. Install and neatly route the wired door open/close magnetic sensors along the top rail/tracks. Plug both units into the overhead power points and tidy up the wiring. Important Equipment Note: Garage ceiling is approx 4.4m high, with motors suspended at around 3.8m in the center of the garage (no wall to lean against). You must bring an 8ft (2.4m) or larger freestanding A-frame / double-sided ladder. Location: Baulkham Hills, NSW

I’m looking for someone experienced in repairing mirrored wardrobe sliding doors. There are two issues that need to be fixed: 1. Sliding doors stick and don’t move smoothly * Both mirrored sliding doors are difficult to slide. * They slide reasonably well at one end of the wardrobe but become noticeably harder to move as they approach the opposite end. * The rollers, tracks and door alignment will likely need to be inspected and adjusted, repaired or replaced as necessary. 2. Loose mirror edge trim (safety issue) * On one of the mirrored doors, the protective edge trim/channel running down both vertical sides of the mirror has come loose and is separating from the glass. * This leaves a gap where someone could potentially cut their finger on the edge of the mirror. * The trim needs to be securely reattached or replaced if required. Please bring the necessary tools and any common consumables. If replacement parts (such as rollers or trim) are needed, please let me know before proceeding with any additional costs. Photos are attached showing the loose trim and the wardrobe doors.

Repair outdoor ceiling that is broken and fallen off

Hi - I have got tiles on tiles done on my bathroom . I need a handyman or carpenter to trim and put the door back . Less than an inch trimming required in my view

Please find attached photos. Need a sliding door 2.34-2.35 x 1.11m with 35mm thickness. Need for it to match the existing ones. Need a supply and install.Please send through offers