Find a professional staining service in Outer South West Sydney

I’m looking for an experienced professional to sand, stain and seal approximately 75 square metres of timber floorboards. Details: • All areas are on the ground floor • Easy access • Looking for a neat, high-quality finish • Open to discussing stain colour and finish options Please include in your offer: • What’s included (repairs, gap filling, number of coats, drying time, etc.) • Your availability • Examples of similar work, if possible Thanks, and I look forward to your quotes!

Stain large back deck very carefully so that the stain does not drip through onto living area underneath the deck. Stain will be supplied

Hi, I’m looking for someone with experience in timber finishing or painting to help sand and stain the handrail on my staircase in my new home. The job involves detailed sanding of the timber, progressing through finer grits (around 150, then 180 to 200) to achieve a smooth, even surface, followed by staining for a neat, high-quality finish. I’m after someone who has done similar work before and pays attention to detail. I want to use Black Japan Feast Watson ( PROOFTINT ) for stain.

Just need to restrain front deck steps and railings.

I have a stain on my carpet I have tried getting it out it has come out a bit but there is still a faint line. It is a delicate Persian carpet so will need it professionally removed

I have a house inspection tomorrow between 1-4 i need the plain white door to match the wood look door. As shown in pictures

Sand and stain 2.4m front door and surrounds, 3-step front entryway (5sqm max) and rear deck (45ish sqm)

Sand back and stain outside deck 8m x 6m

I need to re stain the decking around my pool area, approximately 23 sqm. Water pressure clean first then re stain (Black Japan timber decking Stain)the stain cost in bunnings is $150 I need the concrete area on the side of my house repainted. approximately 39 sqm. Water pressure clean first then repainted, Driveway to be water pressure clean I need all done by the Tuesday 7th October as my house will go on the market.

I want my deck re stained, I have the stain, you will just need the brushes and equipment

Theres a small scratch in the bonnet of the car and a concrete stain on the roof needed to be buffed out, I’ve used a concrete spray remover which did a good job but I want to sell my car and would like this looking good as new

Install a stainless steel(SS) natural gas(NG) hot water tank and To remove my old Rheem Stellar 130lt. NG h/w tank

Need oil stain removed from concrete

Stain main door , some sections of facade timber and 3 piller in balcony

Large pine bookshelf currently light, wish to have stained black. Will need sanding and staining.

Seeking handyman/carpenter to rejuvenate the timber located at the roof of the front entrance. The job requires sanding and restaining. Oil based stain has already been purchased for the task.

To remove white chemical strains on bathroom room gold steel door cause by mould spray.

To retouch gold paint on bathroom side steel/ remove the white stain, white stain is because of mould chemical we used

I need a piece of stainless steel re-welded back onto a bench to fill a section that was cut out. We still have the original cut-out piece. In addition, I’ll need some sturdy legs added to support a 120kg machine on top of the bench. Material will need to be supplied for the legs. Job is located in a shopping centre, hence will need to be done after hours. SWMS will need to be provided and an online induction will need to be completed. Let me know if this is something you can help with. Thanks!

I don’t know what’s happened but I have lackered floorboards and I’ve notice there are some stains. I need it repaired