Find a sockets and switches installation professional in NSW

I need to relocate a light switch and fan switch to the opposite side of a door way. As seen in the picture

I need a licensed electrician in NSW to replace three existing power points. I will supply the new power points. Thank you.

I am looking for a qualified electrician to help inspect and install new wall sockets in our business premise.

licensed sparky need you at mine for 7am Iv got a plug socket at the bottom off the tv wall and Iv got someone building me a feature wall with floating tv unit so would like the sockets moved to behind the tv unit if that makes sense.

fix two dimmable bedroom lights that are flickering. I’ve replaced the bulbs with new dimmable LEDs, but the issue remains. Suspect faulty dimmer switches or wiring. Looking for diagnosis and repair.

I need two light switches changed. These light switches also need to be bought from bunnings, I will pay separately for this.

3 double floorounted power sockets already purchased just need installed, easy access under the house to both floor and under house wiring Fitted close to each other maybe 2-2.5m apart double socket about 3m away

I need to replace 2 power points and 2 light switches. 1 set is in the bathroom on a tile and the other is in bedroom. I have the replacement parts. Just need to replace them and fit them on the wall/tiles

I need 2-3 electric switches and light fittings for outdoor.

I’m looking for a licensed electrician to install a couple of new wall power sockets and tidy up some existing messy wiring. I’m after someone who takes pride in their work and can deliver a very neat, clean, and professional finish. Please only get in touch if you’re experienced and have attention to detail.

I just need to replace five old wall light switch with the budget of $150. Please contact me if you hold a electrician license near Liverpool area.

Need a licensed electrician to replace 3 light switches, 3 double power points and 1 bathroom batten light fitting. I have already purchased all the replacement fittings. Please install them and test that everything is working properly. Photos attached

Need some cables running in kitchen for new power sockets On the image, the Red is existing power The left hand corner is where the mains power for the cooker is which will need running behind to where the new cooker placement is going. I’ll need power new slot which is the green section and there is another PowerPoint below at the bottom of the kitchen the back which will be used for the cooktop but currently doesn’t seem to be given off any power.

Screw in 3 light switches 1 power point 1 light

I need a Qualified Electrician to provide and install 3 light in my flats and fixed one light switch please. You need to provide tax receipt or invoices. Photo attached

Looking for an electrician to complete a small residential job in my apartment. The apartment was built around 2000, so the wiring is relatively modern and I don’t anticipate any major issues. Work required: Light switches and power points + two LED lights replaced, includes - * Replace 11 × double power points * Replace 1 × quad power point * Replace 6 × single light switches * Replace 1 × two gang light switch * Install 2 × two gang LED dimmer/switch combinations * Might need 1 × surface mounting block (bathroom) * Install 2 × new Martec Fino LED ceiling lights, replacing two existing LED ceiling lights (same locations, pretty much the same lights just a bit bigger, no new wiring required ect) I will supply everything, it’s Clipsal Iconic and I think the old ones are HMP: * Clipsal Iconic switches and power points * Martec Fino LED lights * Dimmers * Mounting block I’m looking for: * Licensed and insured electrician * Neat, professional installation * Experience installing Clipsal Iconic products and LED dimmers Preferred, not necessary though Photos of the existing switches, power points and lights can be provided if needed

Need a licensed electrician in Sydney to adjust wiring for ceiling fan/light switches. Currently there are two switches: 1. Low light 2. Main light + ceiling fan together I’d like it changed so that the fan is linked to the low light instead. Main light still needs to work properly. Please quote including callout/labour.

Need qualified Electrician to: 2 x replace existing 4 gang mechanical switch to new 4 gang smart switches 2 x replace existing 6 gang mechanical switch to new 4 gang smart switches 1 x replace existing 3 gang mechanical switch to new 4 gang smart switches 1 x replace existing 1 gang mechanical switch to new 2 gang smart switches 2 x replace existing 2 gang mechanical switch to new 2 gang smart switches 7 x replace existing 1 gang mechanical switch to new 1 gang smart switches Switches I have purchased: https://amzn.asia/d/0eCM9VSb https://amzn.asia/d/0dQzODls https://amzn.asia/d/0gJdQbvq Install a recessed plug - to mount a magnetic plate for iPad as per: https://community.home-assistant.io/t/floating-ipad-dashboard-wall-mount-that-is-charging-magnetic-and-detachable/956322 I have purchased: https://kuxiu.co/products/kuxiu-x39-pro-max?variant=46232839356468 and looking to mount.

Needing a certified electrician to replace: - 12 x double power-points - 1 x single power-point - 1 x 2 gang light switch (light + bathroom fan) - 1 slim light switch - 1 regular light switch We will provide the hardware. We just need someone to do the work (with their own tools). We are available most days any time. Power points and lights work, we just want to update them with new switches. Happy to pay cash

We have repainted our house and we need the below installed: - light switches (replace old ones with new ones) - powerpoints (replace old ones with new ones, add a couple of new ones) - downlights (install new lights in lounge, dining, bedrooms and a couple of other places, ie, hallway, etc) - exhaust fan in bathroom - light on front porch (replace existing light) The property is a small three bedroom house. We will cover the cost of the equipment, ie, lights, switches, etc, or go to Bunnings and get it. We would like to pay for labour ideally between $60 - $90 per hour. Estimate there is around 10 hours worth of work.