Find a professional planter box contractor in NSW

I’m after a carpenter or landscaper to build an open bottom planter in this space with pine timber sleepers. It should match the box on the left, which I've painted monument. It will replace the smaller steel planter in the photo which is too small and I don't want to continue these in the space. It would be roughly 700mm wide, 6000mm long and 600mm high (3 sleepers). Happy to order sleepers from Bunnings if you can pick up.

Supply and build a wooden planter box measuring 110cm x 40 cm x 40cm Type of gardening: Other Size of garden: Under 50m² Has green waste bin: Yes

I'm looking for an experienced and professional tiler to tile an existing long concrete planter box located at the front of my house. The planter box has already been constructed and waterproofed, and I would like it professionally tiled to achieve a clean, modern, high end finish. Scope of work: Prepare the existing concrete surfaces for tiling. Tile the internal walls and base of the planter box. Tile the top horizontal edges/capping of the planter box. Ensure neat, straight edges, consistent grout lines and professional corner finishes. Cut tiles neatly around the existing PVC drainage/irrigation pipes. Ensure existing drainage and waterproofing are not compromised. Additional information: The planter box is long and narrow, as shown in the attached photo. Waterproofing has already been applied. Tiles would be supplied Looking for a good finish, as this is a prominent feature at the front of the house. Please provide a quote for labour and installation, along with your availability. Photos attached for reference.

I’m looking for someone to build simple, budget-friendly timber planter boxes along my fence line. Please measure the areas and quote for materials and labour. I’m after a basic outdoor timber design, with drainage and an appropriate liner. Please list the proposed dimensions I can provide photos and arrange a site visit.

I have a long, narrow raised garden bed in my courtyard (approx 2.4m long x 500mm wide, masonry walls both sides). I want it covered with timber decking boards so it works as a bench seat. What I need done: • Cut and fit 4-5 short bearers across the inside of the box, packed and levelled so the boards finish flush with the top of the masonry • Lay decking boards lengthwise and screw them down to the bearers • Leave an open gap in the rear board where the sewer pipe comes through. • Seal/stain all faces including undersides and cut ends Important: • This is a rental so nothing can be drilled or fixed into the masonry or the house wall. The whole thing must sit in as a removable tray held by its own weight and a snug fit. • Timber-to-timber screws only. I’m happy to provide materials if you let me know what you’ll need. You just need to bring tools. Should be a 2-3 hour job for someone with the right gear. Ground floor, easy access through the side gate. Happy to discuss timing — weekends or weekdays both work

Customised planter box made for me Inspo pic uploaded.

2 Planter boxes made out of treated pine 6000 x 600 x 400 and 3000 x 600 x 800. Installation requires narrow trench <150mm and width of 100 mm in soil length of long sides ie 6000 & 3000 x 2. Easy level access.

Brickwork is still in place but mortar joints have failed and bricks are misaligned, some are also cracked.

I have concreted rendered planter beds that have been painted. I need them repainted, after surface preparation, with a Dulux Avista concrete sealer paint. I’ve chosen the colour. There is a crack that would need to be filled too. It’s not a big area and very accessible. Ideally the job would be done the week commencing August 24. Thanks for taking a look at the job

We have 11 planter boxes finished in raw concrete although made of fibreglass that need a light sand and two coats of paint allow an hour or two between coats. Paint and roller supplied. The planter boxes are 1 m long each photos as attached.

The wall of is about 21 bricks wide and 3-4 bricks high. The planter box only need a matching black paint on top and front as shown in photos. I have paint with me.

We need a standup desk assembled in an office and then a planter box moved about 50 metres - Here is the desk https://desky.com.au/products/dual-melamine-sit-stand-desk?variant=34972759392412

Hoping someone can build me a timber planter box similiar to this with drainage holes - approximately 2m in length, width about 40cm

Please hang planter boxes on the wall pictured. Also remove hanging wall hose

Waterproofing of a small planter box (triangle shape as per picture) Depth 0.7m x Length 3m x width 1m Can provide the material required (please provide the list prior to the job)

Hello, I'm on the strata committee for a 60 unit apartment block in Parramatta. We have 3 planter boxes that need new waterproofing. Our building manager says according to NSW Gov laws we need to involve a design practitioner. Please quote to do that component of the work. I believe it entails visiting, writing the specification for waterproofing work, sending out the tenders, reviewing tender responses and advises us on the risk with each offer, award the work, supervise the work or inspect the work at key stages, write up defects for the contractor to rectify, re check the work. Write us a letter to say all is good. Submit all documentation to NSW Government as required. Must be fully licenced and qualified to this whatever that licence is for waterproofing in strata buildings.

Collect free soil form Vacey postcode 2421 and the delivery to Metford 2323 Fill planter boxes out back of property with soil. Will need shovelling approx 2m3 2x Planter boxes are approx 5000x500x500 Will not be filled to the top - I will be using topsoil ontop

Looking for someone todemolish a cracked concrete planter box and remove the tree stump inside it. The planter is located down a side path directly against a brick house wall and door frame. This is a tight-access job requiring manual hand tools—no large machinery or heavy stump grinders can fit or be used safely against the brickwork. Scope of Work: Break & Demolish: Break apart the 4 sides of the old concrete planter box (it is already heavily cracked). Stump & Root Removal: Cut down and remove the main stump/root ball as close to ground level/below pavers as possible. Care must be taken not to damage the adjacent brick wall, footings, or door frame. Disposal: Completely dispose of all concrete rubble and green waste

Have a courtyard and want planter boxes approx two metre long on each fence line.

Needing 3 ceramic outdoor planter boxes in classic cream colourbond colour. 67cm x 23.5cm x 25 cm high.