Hire a trusted car oil and filter change professional in VIC

I need someone who can service my LDV G 10 van get and change oil + filters and do the necessary maintenance and turning. It’s petrol van 2CP1AL. If all good I have 3 other cars with pending service 2CP1AK, 2CP1AD & 1EX7UT

I’ve purchased a new fuel filter and need someone to install it in my 2013 BMW 520D. Happy to drive down to you or your shop

Replacing/fixing what I believe to be fuel filter issue in my partner's 2003 Holden Cruze. We will supply the replacement filter.

I need the fuel filter in my 2003 Holden Cruze replaced. I will supply the replacement filter. $150 ONO

Volkswagen Golf 2017 wagon 145000kms oil service

I need someone to change the oil and oil filter for my Toyota Vitz 2011 I have oil and filter

I need someone to come and change the oil and filter of my car I drive a peugeot 2008 2017 model

I need to have the oil and filter changed on my car today at 4 p.m. at my home.

I have a Ford escape, n need oil n filter changed on my car. I have both oil n filter, just need someone to change it as I don't have any jack to lift the car.

Open to quotes and flexible with time thanks

In middle of oil change but can’t get sump plug off as can’t find the correct socket Car is jacked up in garage, has Liquimoly engine flush in it so not drivable Car is Mercedes Benz 2014 A200

Need experienced mechanic service 2 cars – must follow exact oil change method. Oil and filters Supplied Description: Looking for someone to do an oil and filter service on 2 cars. This is not just a normal quick oil change. I want the job done exactly to a specific method step by step, so I need someone who is careful, patient, mechanically minded, and happy to follow instructions properly. Please only apply if you’re confident doing the below exactly as requested: Required oil change procedure: 1. Start with the engine completely cold. 2. Add about 1 litre / 1 quart of fresh oil to the existing oil as a pre-flush. 3. Start engine and let it idle for exactly 5 minutes. 4. Turn engine off and wait 10 minutes. 5. Then drive the car 10–15 minutes to full operating temperature. 6. Park on level ground, let it idle 2 more minutes, then drain the oil immediately while hot. 7. After the first drain, leave it for 30 minutes, then remove the drain plug again and do a second drain. 8. Fit new oil filter, but pre-fill the filter to about 60–70% with fresh oil first. 9. Apply a thin film of oil to the rubber gasket and hand tighten only. 10. Refill engine slowly with about 80% of oil capacity first. 11. Wait 5 minutes, then top up slowly in small amounts, checking the dipstick each time. 12. Final oil level should be around halfway between low and full, not overfilled. 13. After refilling, do not start the engine straight away. 14. Turn ignition on without starting, wait 10 seconds, then turn it off. 15. Repeat that 3 times. 16. Then start engine and let it idle for exactly 3 minutes without touching the accelerator. 17. Check for oil leaks around drain plug and filter. 18. Turn engine off, wait 2 minutes, then re-check oil level and top up if needed. Must Have • has experience servicing cars, or is very mechanically capable • has their own tools • works cleanly and carefully • is happy to follow this exact process, not their usual rushed method

While topping up engine oil , I added more oil than required. As shown in picture. So it's well above the maximum mark. Although I don't see any immediate problem, I would like to remove excess oil and just keep to the mark. I don't require change of Engine oil or any other services...just extract excess oil. Vehicle:- Honda Accord 2006 model ivtec.

Mobile Oil & Filter Change - 2017 Hyundai Tucson 2.0L Petrol- SUPPLY PARTS Description: • Vehicle: 2017 Hyundai Tucson 2.0L petrol SUV (~130kW G4KD/Nu engine). • Service: Drain old oil, replace spin-on filter (Ryco R2732P or equiv.), refill 4.8-5.3L 5W-30 full synthetic (API SN/SP, ACEA A3/B4), reset service light if needed, check leaks. • Tasker supplies oil and filter • Location: Black Rock VIC (easy parking). • Licensed/insured; itemised invoice with GST. • Budget: $200-260 all-in (matches my last service)

Put 5W-40 in my diesel Mitsibishi Triton 2010, and didnt realise it would be such a big issue. Shouldve been 10W-40 Now my engine has slowed and smoked and afraid to start it. Broken down on Hume freeway just outside of Beveridge. If anyone can get the 10w oil and do a full oil change and get the car running before i have to call a tow truck that would be awesome.

Description: Looking for someone experienced with basic car servicing to help with a job. Car: 2014 Mitsubishi Lancer ES Auto (petrol) Work required: • Drain old engine oil • Replace oil filter • Install new drain plug washer • Refill with new engine oil • Add petrol injector cleaner to fuel tank • Dispose of old oil and filter properly Parts supplied by me: • Penrite oil filter PF1004 • Gulf Western Premium Energy 10W-30 (5L) • Nulon petrol injector cleaner (300mL) • New drain plug washer Notes: • No engine flush • No transmission work • No brake work required • Please bring your own tools and oil drain pan Car will be parked on level ground. If anything else you beleive is required please let me know. Car has been stationairy for roughly a year.

Need an oil and oil filter change. I can supply oil and filter.

Take the sump plug for first oil change for my Suzuki Jimny. 14mm - 17mm bolt on there.

I have new oil and filter but to complete the oil change I think the car needs to be lifted to get under car access. Under car access is required to remove the under engine cover, which will then give access to the engine sump plug. The oil filter is accessible from above. Can drive to you.

Need to service my 2010 Mitsubishi outlander oils just about bone dry in the atf haven’t checked the rest