Find professional metal gate repairs in VIC

The solid metal gate does not close or lock, as shown in the photos. It requires necessary adjustments, weldin g or removal of pieces

The front gate needs to be stripped and repainted. I’ve already stripped a section of it on the inside and out, as shown in the phtot— please provide a quote for the job.

The entrance metal gate Hinges need to be lifted, The concrete has lifted its difficult to open

I have some driveway gates that I would like to be installed. Currently there is not anything to hang them off. Youd need to build the brick pillars on either side so that it has something to attach it to. I will also require a pedestrian gate to be installed. As this gate needs to fit in the gap between the driveway gates and the current fence there may be a small amount of modifying a metal gate to make it fit

Replace broken hinges on metal gate frame as per attached photos. Quote should cover cost of new replacement hinges if needed.

Need to weld old hinge back on or replace.

Fix a metal gate. Needs some welding and hinges fixed. The gate has fallen off.

The gate open upward to the slope, left side seems drop down scratching the floor, right side the screw come off. So now the door doesn’t close and lock. Need to fix it

Metal gate - hinges have come away.

I need one metal side door in wollert east Sample in photo Looking for quote

There was a small accident where a car ran into the gate and bent it, now it's stuck open and we can't close it or unbend it.

Need a brass plaque screwed into a metal gate. There are screw holes on the brass plaque and it is quite heavy.

I have been told this is a big job. I have mobility issues and the gate is too heavy for me to comfortably close each night manually. Cost to electrify it? Quoted $6000 which I think is outrageously high. Any advice much appreciated

I have 3 outdoor metal gates (1 front entrance gate and 2 side gates) that need adjustment. They were all working fine before, but due to minor alignment shifts over time, they’re no longer closing properly. All hinge are same type as pictured. The front gate is now very tight and difficult to operate. The two side gates aren’t closing or latching properly. Looking for someone experienced who can realign and adjust the gates so they open and close smoothly again.

Move and replace metal hinges (3) to allow gates to close . Add vertical bolt

Repair and paint metals gates

Metal gate no longer closes. It hits the upright.

Metal Gate fixing loose - need to permanently secure the fixing as attached. Tack Weld the screw/washers to the metal post Minor Alignment of gate

i have a colourbond gate that needs to be fix the bottom bit comes lose and the latch is not aligned) (currently was held together with cable tire and stick) the price must incl. all materials and labour location: west Melbourne 3003 (as in cbd)

Take away old cupboard and metal gate. Access via laneway at back of house.