20 Mazda Service in South East Melbourne

Transmission rebuild on a FN4A-EL Mazda 3 2009 BK

I have a 2008 Mazda3 manual. Earlier today I accidentally started it while in 1st gear and it shook briefly. I continued driving for 5 minutes and noticed a burning smell. After parking and turning it off, the engine now won’t start — no crank or click. The dashboard lights stay on, but the radio shuts off when I turn the key. I’ve tried jump-starting, but no success.

Replace Mazda 3 BK cabin filter[ filter provided]

I’ve installed a 2016 Mazda 3 steering wheel into my 2014 Mazda 3 (2.0L petrol, Australia model). Steering wheel fits fine, and most buttons work (audio/phone), but cruise control does not activate. I believe the button wiring or signal is not compatible between the two year models. I need someone with experience in car electronics or Mazda wiring to help do one of the following: – Check cruise control signal wiring from the steering wheel – Possibly adapt the button module wiring to match the 2014 system – Confirm if clock spring or button signals are mismatched I have 2016 model airbag ready to be installed with newer steering wheel. First picture old model, second picture is newer model for your reference. I will assist and provide access to the vehicle in a safe, well-lit location.

I would like to have the engine oil and oil filter replaced on my Mazda 6 sedan. I will be supplying both the engine oil and the oil filter for the service.

Need a dashcam installed on a Mazda cx-30, I have the dashcam and hardwire installation kit.

Need a generic headunit installed along with the 360 degree cameras it comes with as shown in the photo. Price has to include calibration of the 360 degree cameras Also need a viofo a229 plus front and rear installed with the hardwire kit installed at the same time. Happy to pay cash can work out if offer Happy to drop off car or have someone come do it at mine

Mazda 3 2012 Model. Car Motor broke down because we did not change Oil

The car was running fine. There were no errors displayed on the screen. The car is not starting

My 2006 Mazda 6 timing belt wore off and my mechanic said we need to replace the engine, to get it working. I got a new engine and now I need someone to remove the current engine and put the new one in, please send me your best offer

Need to install a dashcam for Mazda cx5 covering rear too.

Mazda 6 2013 model old keys not working after replacing batteries. Need new key/ repair

I would like to install a Viofo A229 2 CH dashcam for front and rear on a 2022 Mazda CX5. The install should not damage trim or working of the airbag please. I also do have the hardware kit. Happy to discuss dates and timings.

Replaced a new stereo system on the car and needed the reverse camera to be connected. The car already has a reverse camera, just needed to connect to the new system.

Price of tinting Mazda tribute 2007 window.

I have a 2003 Mazda 6 that I want to install reverse camera and parking sensor for. I don’t have the devices and equipment needed for the job so I expect you to have what’s needed for this model

Remove existing speakers and install new ones (need someone that has experience to ensure panels get replaced properly)

Install differential on 2000 Mazda Ute Old 1 has been removed had to give the old to the wrecker

2014 Mazda 3 Neo, need installation of a reverse camera

Car not running well. Engine light on. Low revs in idle and runs the same, looking to stall often. Have changed battery, alternator, MAF sensor, cleaned intake, changed air filter, changed fuel filter, run injector cleaner, changed oil and filter but no change