Find a trusted local light installation service in NSW

I’m looking for a licensed electrician to install: • A light in a small wardrobe/storage space • A power socket inside or near the wardrobe • Appropriate switch/control for the light There is easy access to the electrical supply in the wall where the socket will be located, as it is the same wall as the laundry. The wardrobe is a small space, so this should be a relatively straightforward installation. Please include labour and materials in your quote, and let me know if you need photos or measurements before quoting. Important: Must be a licensed electrician and complete the work in accordance with Australian electrical requirements.

Replace a current LED down light with a hanging ceiling lamp. The ceiling light is not directly over the table. It would need a hook in the ceiling so the lamp can hang over the correct spot. Sort of like the reference in the attached image.

Licensed electrician Install a mirror Install two lights Unscrew a shoe rack Change a few door fly screens

1. Install 4 down lights in 1 room (pic 1) 2. Install 2 sconces on walls (pic 2) 3 move double plug socket 500mm (where a light switch and phone point are) (pic 3) Isolate the light switch and phone socket, as these are no longer required. Hoping to get these done asap (particularly point 3, as it’s delaying another job)

We're setting up a small built-in desk nook at home and need a licensed electrician to help with the lighting. I've attached an AI mock-up so you can see the look we're going for: three floating timber shelves with warm LED strip lighting underneath, above a desk. What we need: - Supply and install the LED drivers/transformers for the under-shelf strip lighting (we'll provide the LED strips) - Install a switch so we can turn the shelf lighting on and off - Keep cabling and drivers as hidden as possible for a clean finish The desk is being installed on Friday 2 October, so we're looking for someone available beforehand.

Replace 4 light fittings. Lights to be supplied

I need someone to install a hanging display frame from the ceiling. The frame comes with the mounting hardware, screws and 2 m hanging wires. The job involves drilling 2 fixing points into the ceiling, installing the frame and adjusting the wire length so it hangs level at the required height. The tool needed to adjust the wire length is not included, so please bring the appropriate tool. Screws and mounting hardware are provided in the set.

I would like a qualified electrician to purchase and install new light fittings in office

Have two pendant lights to be installed replacing halogen downlights.

Rebooking task between James and Manogran

I’m looking for a qualified and licensed electrician to supply and install 3 new light fittings, including globes, at my property. There are: * 1 light fitting in the garage * 2 light fittings in the carport/driveway * The existing fittings are the older fluorescent-style fittings shown in the photos. * Two of the existing lights are no longer working. * I would like all three fittings replaced with suitable new LED light fittings, including the appropriate globes. Location: Garage and carport/driveway areas – photos provided showing the exact locations and existing fittings. Requirements: ✅ Must be a licensed/qualified electrician ✅ Must be appropriately insured ✅ Supply 3 suitable replacement LED light fittings and globes ✅ Test all three lights to ensure they are working correctly I’m happy to consider recommendations for suitable fittings, but would prefer good-quality, practical LED fittings rather than anything overly expensive. Please provide your quote including labour and supply of the three fittings/globes. I’m flexible with timing and can arrange a suitable day/time. Photos of all three existing light fittings and their locations are attached.

I need 6 light fittings replaced and one 3 in 1 fan light heater for the bathroom replaced as well. I have the light fittings.

Looking for a licensed electrician to do a small lighting job in a salon/treatment room in Paddington. I need: • Existing hanging/pendant light removed • Replaced with a recessed LED downlight to match the existing downlight in the room as closely as possible • Existing light switch changed to a dimmer switch • Please make sure the new downlight is dimmable and compatible with the dimmer • Ideally I’d like the finished result to look neat and flush with the ceiling I’ve attached photos of the existing light, nearby downlight and switch. Need you to supply the downlight/dimmer — please include materials in your offer. Must be a licensed electrician.

So I tried to do it myself and the steel plate was stuck on it, I need an actual electrician to help with this. I’ve got all the parts to attach the new lighting fixture

We need help replacing four of our current light fixture with a pendant light. We have purchased “HAVSDJUP Cord set, white, 1.4 m” from IKEA. Photos of current light attached in photos.

Remove 2 disused telephone/modem wall outlets (old cream Telstra-style plates) and blank off safely Install a dimmer switch for the bathroom light Metered parking in front of apartment or all day visitor permit available for street parking

I hung up a lampshade (second picture). I will remove this myself but need the original Oyster light reinstalled and connected to the wires. ‼️I do not have power tools or a stepladder so you need to have a drill and options to reinstall the lamp. I do have the original screws‼️

Want the current light taken off and new light installed. 2nd picture is of new light

Two ceiling fans being replaced and add a few downlights to a bathroom. Replace old electrical sockets. Require a licensed electrician

I need to get 4 new pendant lights wired and installed in our office. We have recently had a linear lighting strip put into the reception area - the building management pulled down the 2 older pendant lights we had in there so we want to have new pendant lights put pack up. We also want to replace the 2 pendant lights in the boardroom with the other two new pendant lights we have. There should be existing wiring in place for all pendant lights already.