Find trusted glazing experts in VIC

I need two windows replaced both with new glass that would need to be supplied. The first window is a small 57cm x 46cm toilet window. Current I have an old slate window but just want one piece clear glass. Then an old bathroom window again want one clear piece to replace to let light in. Photos and measurements attached

Window cracked. Ground floor- easy access externally. Might have some other windows to look at as well.

The top window panel of the windows on my stairs has shattered and needs replacing, need someone who’s a qualified Glazier, The window is high up but not to high from the ground. Happy to negotiate the price depending on the size and the type of glass required.

Hi - I’m looking for a glazier to cut a hole into our kitchen splash back for the installation of a new power point. Blue circle in image is where hole needs to be cut. Thanks!

I require a licensed glazier or an experienced handyman to replace the existing window sash locks with the new ones I have purchased. It's a simple and easy job that wouldn't take more than 30 to 40 minutes for a qualified tradesperson to complete. Please contact me to schedule this service promptly.

Require round hole 230mm cut in small pane of glass to fit dog door Glass is single pane 3mm glass

Need a handyman for glass repair and change

Glass replacement on front door. Bottom pane on door Please quote

Need a glasss repair its of bedroom

We'd like to update the front door to allow more light into the the house by replacing the 2x frosted glass panes with 5mm clear glass. 1. remove/replace existing frosted glass with 5mm toughened/ laminated (advice) 2. each frosted pane to be replaced is approx 1050mm highx255mm wide (let me know if you need to inspect) 3. supply and install all beading/quad(?) around the glass to complete the job. Hopefully only one side needs to be replaced. 4. front door is 40mm thick We're in Blackburn South

I have one of those all fixed windows in my toilet that i want to replace for a window. It could be slide window, awning window or anything else. I am not fussed about the type of window and want a cost effective solution as the window will only be temporary until we renovate in a couple of years. Do not need double glazed or anything, and I am open to use 2nd hand windows if it helps the price.

Hi need glazier or handyman to replace broken window.

Aprox 31cm long, 10cm tall glass pane is broken on internal door and needs replacement. Clear, see-through replacement glass is fine, it dosen't need to be red. The broken glass will need to be cleaned out Please quote inclusive of all parts and labour to get door back to normal.

Crack in the glass of the entrance door, to be repaired or replaced. After quote and timeframe.

Need someone to replace the window broken glass, measurementof glass is roughly 45 × 45 cm. Please send me your offers.

Needing glass repair on window. Need to inspect and quote.

X 2 glass panels broken. Approx 1000mm x 500mm 500mm x 500mm

Hello, I require a replacement of a glass panel next to the door ( you can see in the photo it’s been shattered inside). The visible glass panel measures: 275mm wide 320mm high Located in glen Waverley

Looking for a glazier or glass door expert to help fix an office door that is slanting down and scraping the side frame, making it hard to open. See attached photo. Please don't apply if you don't have the tools or know how to fix one of these.

Job is in Rowville. Supply and install pet door medium size in glass. Glazier preferred I may have other works