Find a professional gate installation in South Adelaide

wanting a fence done along the paver to garden edge, 1.2m high, with a gate infront of the stairs. I have added a picture of the picket/vertical slat style im after. also pictures of the area and drawn in red the area refering too. Will need posts concreted in for majority of fence. Total legnth of just under 19m

The Kwickfit Springs on a self closing pedestrian gate have lost their spring. Gate is in good condition.

Have an Alpha Automation solar sliding gate set up, the batteries aren’t holding charge overnight or on overcast days. I think there is water getting into the wiring somewhere as it’s only recently installed and was previously working. The sensors and add on to the garage door motor haven’t been connected so need them done too. Prefer a Saturday but could make during the week work.

Small front gate to the property has come off, needs to be welded back on. Minor job.

Need installation of a Delf Push Button Digital Gate Lock on a Colorbond side gate. Lock supplied. The gate frame is approx 3cm wide. The metal post fixed to the bricks is approx 5cm wide. The backs of the lock are approx 5cm wide.

I want to replace front and rear doors, also side access gate of a rental property which had been damaged by the previous tenant.

Automate gate or replace if needed. Currently not automated.

I need my low front fence and side tubular gates spray painted Need experience with a spray paint gun and supply your own spray gun we will be getting both prepped and supply paint so you will just need to do three coat on each

Expanding car port by moving 2 pillars outwards and installing gate preferably by using the existing Iron sheets. I'll pay for the material cost like hinges, posts for the gate, frame for gate etc

2 pool aluminium gates need repair as not closing, they may need new safety latches

Side gate needs repair. As a part of repair the column or metal beam in which the door latches into has broken. Mobile welding will be required to weld the beam to the base beam and ensuring its aligned so the gate can close and lock into it.

Install automatic gate. 1.8m by 3.6m. Need done ASAP so First person to contact will get the job.

Have replacement gate motor to replace existing broken motor

I need a picket fence put up to replace the old metal one (pictured, it has since been removed). I haven’t sourced supplies. It's about 3m wide. I am hoping for a fence that stops my dog from jumping up and over/blocks a bit of the street view. There has been a Colourbond fence installed to the left and it can join onto the brick of the house. Pavers underneath go to dirt so I don't imagine it being a tricky job.

Need stripped 14G tek screws in my side gate hinges replaced with an m8 hex head bolt, nut and washers combo . 14G screws are all stripped and think the best replacement would be a bolt going all the way through. Post is 50mmx50mm

I have 2 x side gates (flat pack) to put together Then require timber to be attached for a screen. All materials for the job are here - screws, wood etc. No cutting of timber is required. You will need a drill

We have a glass pool fence/gate that used to be self closing, but no longer does this. It stays ajar and we are concerned about safety. My husband tried to take it off hinges and rescrew, but didn’t fix it.

Side gate needs alignment and the hinges need to be tightened.

Have a structure made and up temporary So dog won’t escape But need done properly

There is a small gap under my gate that my dog can squeeze under. I need it fixed so he's no longer Houdini.