Find a professional gate installation in Prospect SA

We have an old solar gate for our property that we need to replace and convert to electric. We can arrange electrician, but need assistance with measure and install of new gate and removal of old.

Supply and Install NEW Side gate with post and d latch. Approx 1150mm wide

The gate has come off the hinge a bit. It does not close properly and is not secure. There is also a smaller gate on the other side of the home which needs repair with same issues. Photos on request. Thanks :)

2 Grunt gas struts to be installed on SR5 tailgate Instructions included Requires socket set

Latch on gate broken. Needs repair

The motor for my electric sliding gate has lost power. The electrical socket which it is plugged into does have power going to it because other appliances work from that electrical outlet.There seems to be a problem with the circuit board in the motor, I believe.

Our existing swing gates have started to sag and scrape along the paving of the driveway. Removal of rotting timber gate posts and installation of matt black steel posts (new posts to match existing fence posts along the front fence, 120x120x3mm approx, flat capping on top to match other fence posts). Steel posts to be concreted into the ground. Existing metal swing gates will need removal from the old timber posts, then reattached to new steel posts and adjusted to achieve an even and flushed closure. Existing automatic opening/ closing gate motor will need reattachment to gates to reinstate original function. Please state your licences, ABN and warranties on workmanship and posts supplied. Please supply photos of the new steel posts you intend to install. Thank you.

Mebau privacy screen & gate, 4m wide by 3m high

Wireless keypad was knocked off gate and needs to be reinstalled

Two front gates to property, driveway and single access gate, need their posts re-aligning in concrete base to correct lean and allow gates to close properly. Right hand post on double gate is leaning outwards, right hand post on single gate is leaning inwards

I need a hardware mounted baby gate installed at the top of some stairs. The wall has metal studs. https://permachildsafety.com.au/products/1-8m-wide-standard-retractable-gate

Cut a 150mm diameter hole in the corrugated iron roof and install an Abbey Rangehood Flue (kit supplied). Single storey home.

Supply and install 2 x colorbond side gates approximately 180cm x 80cm and 185cm x 95cm If someone can attend to measure and quote first - Due date: Flexible

Started drilling the holes then realised my drill/me is not up to the task. Also, my cheap drill bit snapped off in the hole so will need to get that out as well! - Due date: Flexible

Install a 6ft tall wood-coloured aluminium fence and automatic gate. 22m wide and 4m back towards the house on one side of the property

Pool gate support post was pushed out of alignment and needs repositioning - Due date: Flexible