Find a professional gate installation in Noarlunga

I'm in need of a concrete plinth for a fence/electric sliding gate we're having put in at our house at coromandel Valley. It will be about 10,300mm long, 450mm wide at whatever thickness is recommended for this job. There will need to be a small part of it a little wider than 450 as a pad for the motor to sit on. I'll attach a pic of a drawing the fencing guy did and also the spot. Posts are currently in. Thanks

We are looking for someone to supply and install a new gate/fence between the side of our house. I’ve attached an ai image of something we had in mind. We are open to options and ideas. The space is approximately 3m wide and we want something that is about 1.6m tall. There is an image of how it currently looks as well. Something lightweight and not wood is our preference due to living in the hills.

Look at Shed Roof, Inspect For water Damage Underneath, and replace the rotted plastic corrugated iron with normal Corrugated Iron.

Looking for an experienced concreter to inspect and provide a quote to re-concrete and level the front section of my driveway. I'm planning to have a sliding gate installed, so the new concrete needs to be level and suitable for the gate track and installation.

Gate damage, hit by a car: The side gate is off its hinges with broken and bent parts. The main gate appears undamaged and just needs to be reinstalled.

Gate requires replacement hinges and old hinges removed. Gate will require resetting to allow to open.

Would like a quote for front fence and gate Aluminium horizontal slats in monument grey

My side gate is completely jammed due to retaining wall movement, and looking for someone who can adjust the width (welding).

Remove fence panels and gates, transport to and from powder coater then reinstall

Have an Alpha Automation solar sliding gate set up, the batteries aren’t holding charge overnight or on overcast days. I think there is water getting into the wiring somewhere as it’s only recently installed and was previously working. The sensors and add on to the garage door motor haven’t been connected so need them done too. Prefer a Saturday but could make during the week work.

Need installation of a Delf Push Button Digital Gate Lock on a Colorbond side gate. Lock supplied. The gate frame is approx 3cm wide. The metal post fixed to the bricks is approx 5cm wide. The backs of the lock are approx 5cm wide.

I want to replace front and rear doors, also side access gate of a rental property which had been damaged by the previous tenant.

Automate gate or replace if needed. Currently not automated.

2 pool aluminium gates need repair as not closing, they may need new safety latches

Have replacement gate motor to replace existing broken motor

I need a picket fence put up to replace the old metal one (pictured, it has since been removed). I haven’t sourced supplies. It's about 3m wide. I am hoping for a fence that stops my dog from jumping up and over/blocks a bit of the street view. There has been a Colourbond fence installed to the left and it can join onto the brick of the house. Pavers underneath go to dirt so I don't imagine it being a tricky job.

Need stripped 14G tek screws in my side gate hinges replaced with an m8 hex head bolt, nut and washers combo . 14G screws are all stripped and think the best replacement would be a bolt going all the way through. Post is 50mmx50mm

Pool gate to be realigned

Have a structure made and up temporary So dog won’t escape But need done properly

Split level backyard requiring a balustrade with a gate 3m long Attaching it to a brick wall and gate will be attached to a pergola post aluminium and one post will have to be set in concrete to hold the gate. Also attaching the lockable gate latch to be fitted. All products will be supplied and the concrete and screws supplied