Find a professional garage door installer in VIC

There is no motor attached to it, Currently it’s manual I want to make it automatic. I will be purchasing the unit,or I need installer to provide me a compatible product. Please confirm if you are an experienced specifically for roller doors, please let me know estimated time frame for the installation.

My garage door bottom panel id bent, it opens and closes but not completly sealed due to bending.

Garage door wont open, we noticed the left spring has snapped in two, right spring looks okay.

The ceiling collapsed onto the garage door, and the garage door can’t be opened because it’s trapped under the fallen ceiling.

Double garage door panel to lift the remote door has snapped. It's not pulling it up to open.

Our garage door has some dents and a bit benty, makes it scratches the wall a bit when roll ups/downs. It still functions well and we are just worried the paints got slowly scratched off after long time use. Can anyone fix it? Make the dents less visible is fine. No need to make them completely invisible. But want to make sure the door won’t scratch the wall.

I need help to install garage door seals. This is to stop air and dust flowing into the garage

The ceiling collapsed onto the garage door, and the garage door can’t be opened because it’s trapped under the fallen ceiling.

Looking for an experienced painter to repaint my existing double garage door. Scope of work: * Clean and prepare surface * Sand if required * Prime if needed * Apply 2 coats of exterior paint * Neat, professional finish Please provide: * Your quote * Availability * Photos of similar work

Garage door needs fixing, no tension

Double Panel Lift garage door requires a service - 6 year old door

Our garage door opens fine but when closing it retracts back up. Need it fixing.

One extension spring on my tilt garage door has fully detached — the spring, anchor bolt, washer and rubber bumper have come off at the top anchor point and the spring is sitting on the floor. The opposite side is intact and working, so there’s a reference to match against. Need someone experienced with garage door springs to: • Supply/match correct anchor hardware (part-thread hex bolt, mudguard washer, nyloc nut) etc • Refit and tension safely, door open/supported • Check the working side too, since springs are a matched-age pair Appears as though the bolt has bent and come loose, spring and frame appear to have no damage. Just needs to be reattached

Need a lock and key installed for my garage door

We have a Steel Line automatic garage/roller door that has become stuck in programming mode after pressing buttons on the control unit to try get it to stop beeping for a service it got stuck in program mode. The system is now flashing a “4” and the door will not operate correctly. The motor is not broken as were were able to get to go up and down with the + and - but can’t get it out of program mode. It’s making noise but the door is not completing any movement cycles and appears to be stuck in setup/learn mode. We have already tried basic resets including power cycling, but the issue has not resolved. What we need: * Someone experienced with garage/roller door motors (preferably Steel Line systems) * Reset/exit programming mode * Recalibrate or reprogram travel limits if required * Ensure door is fully operational again Details: * Door currently not functioning properly * Motor still powered and making noise Looking for someone who can attend as soon as possible and fix the issue. ⸻

roller door lost tension on left side pushing it down. ballooning when force opening

One of the hinges on the garage door appears to be broken. This needs to be replaced and the gaps between the frames need to be tightened.

Installation of secrional garage door motor only. 4 section garage, motor attached to ceiling. Please provide quote with and without the appliance(motor)

Frame of the garage door need to be finished, should include material and labour.. Look the at pic to assess. One in the ivory colour is the one that I want framing to look like.

The garage door gets stuck half way while closing, I think there is an issue with the hinge in the middle that guides it close.