Find a local Tasker to inspect your Ford in QLD

Remove and Replace A/C compressor on 2005 Ford Focus, regas and check for pressure

Lost keys has been turning over when try to start but no key and immobilizer engaged

I have brought one of them rear-view mirror reversing camera's and need someone to help wire it up in my 2012 Ford Ranger. Says its wireless buy has some cords and other stuff in kit, see pics.

The pawl spring tab in the rear driver side-door latch has broken. Door cannot be closed.

Fit new winch to vehicle, winch is brand new

Need a mechanical check on a 1997 ford Ecovan, I'm looking to buy it but want to make sure there's no issues with it.

Two front flares have been semi done just need 2x small attachments installed ( the gaps shown in pic @ front ) Also 2x rear flares installed. On a ford ranger Platinum ( have the kit just need installation) Bring own tools.

Ford Ranger 2.2L Diesel – Engine Surging (Diagnosis Required) Looking for an experienced diesel mechanic or auto electrician to diagnose and fix a persistent engine surging / hesitation issue on my Ford Ranger 2.2L diesel. This is not a basic fault and not a parts-swapping job. All common mechanical causes have already been replaced or ruled out, including: • In-tank fuel filter & pickup • Air in fuel (clear hose test) • Injector leak-back • SCV & HP fuel pump • EGR valve • Turbo inlet hose Vehicle still surges with unstable MAF readings. Likely causes now point to ECU adaptation, sensor signal integrity, wiring/ground issues, or ECU control logic. I’m looking for someone confident with live data, wiring diagrams, electrical testing, and proper fault diagnosis. Payment will be made only once the issue is correctly diagnosed and fixed. Happy to pay a fair rate for a proper solution. This job suits an experienced tech, not guesswork or trial-and-error.

I’m looking for a qualified mobile mechanic to come out and complete the following work ASAP. Vehicle details: Make: Ford Model: Focus Year: 2011 Engine: 2.0L 4-cyl petrol (LW Duratec) Transmission: Manual Work required: 1. Remove and replace the water outlet housing (part already purchased) 2. Perform a full coolant flush 3. Refill and bleed cooling system 4. Check for leaks and proper operating temperature Issue: Coolant leak from the water outlet housing – known/common issue on this model. What I’ll provide: ✅ Water outlet housing ✅ Correct green coolant What you’ll need: - Tools - Experience with Ford Focus / Duratec engines preferred Location: Pimpama, QLD Timing: ASAP – or within the next 24–48 hours preferred. Please include in your offer: - Your experience / qualifications - Availability - Fixed price for labour

My 04 Ba Falcon has a faulty starter motor - I have now got the new part ready to be installed however no longer have equipment to do so. Just looking for someone to come do the install car is on flat street easy to jack.

Inspect car fully to see anything is wrong or happened to it and what condition

Motor is ready. I started the job, removed trim, but haven't got around to finishing.

I’m looking for someone experienced in bull bar installations to fit a Next Gen Ford Ranger Raptor bull bar (Diablo – Pre-Runner style) to my vehicle. The bull bar and all required parts will be supplied by me. I’m after a reliable installer who is familiar with this type of work and can complete the installation within one day. Happy to discuss timing and location with the right person.

My ford falcon g6e ecoboost has some issues with shaft

Drivers window isn’t working in my 2016 ford ranger, the other 3 are working fine.

Hi all I'm needing an experienced person to change over my front and back brake pads on my 2013 Ford Mondeo Wagon. I have the pads already and I'm not sure if all are needing to be replaced there's a squeek noise when braking. None of the pads have sensors. I have a carport or I could come to you if you're not too far from me in Lutwyche.

I need my car jump started, I don’t have himp cables

Hi, I need help installing a front and rear dashcam with a hardwire kit (I have the kit and fuse cables) in my Ford Everest Trend (2019). Cable management is important - would like them hidden. Flexible schedule; please share your availability and quote. Thanks!

Install Rear Brake Pads – 2017 Ford Everest Trend (Parts Supplied) Looking for someone to replace the **rear brake pads** on my **2017 Ford Everest Trend (5-cylinder, 4WD)**. I already have the **Bendix 4WD/SUV brake pads** – just need them installed. **Job details:** - Labour only – parts are supplied - Must have own tools - Prefer mobile service (can be done at my location) - Must have experience with brake pad replacement - Flexible with time, but sooner is better **Location:** North Ipswich **Budget:** $130 (negotiable) Let me know your availability and experience. Thanks!

Have to replace the driver’s door actuator in the drivers door. Have the part, just need someone to fit it without causing any damage. 2004 Ford Fairmont BA