Find experienced local fencing contractors in Redland Bay

Re-attach hinge to gate. Weld has broken on one of two hinges.

Supplied Colourbond fence. Straight 23m worth of fencing. Slight slope.

We have had to take our fence down in order to build our house. Only the fence panels were removed. We now require the fence to be put back up. Most of the nails and bolts were kept when taken down and can be reused again. Photos show parts to be done PLEASE NOTE: the last photos show that the fence panels were kept, this is simply a matter of putting them back up. I do not want a new fence, thank you!

Looking for someone to replace the end fence panels pictured with slat fence panels for privacy (approx 20 cm higher than our neighbours fence). I have attached a photo of the panel we are after :)

Just a small gate built. The first airtasker built a six foot week as unfinished load of crap.

We would like an aluminum gate installed at the front of our property. No fencing is required. The width is about 1470mm and height 1800mm. Attached is a photo of the entry way we would like the gate across .

Side gate installation. Approx 1.5m. Prefer aluminium.

replace existing fence - labour only if thats ok - are you a licensed carpenter

Need a fence restored or if I need replaced a quote

18lm of 1.8m high timber fence to new house

Wanting a wooden side gate installed

Repair a section of fence 12 meters timber and replace posts

Install colour bond fencing

Looking at replacing my timber fence and 0.5m of fence at the front to a metal fence that is half pleasing to the eye. We have just moved in to the new house and My dog has been chewing at the gate to get out. A metal gate and fence will eliminate this. Would also like to swing the gate from the other side as the latch rubs on the downpipe when opening.

Cattle proof fencing required approximately 500-1000m

1. Remove existing fencing panel (1.89 m x 1.8m H) 2. Install posts for Stratco gate and concrete in 3. Use part of existing fencing panel, gate frame, channels that enclose gate frame, gate latch and gate hinges to create gate. 4. Use balance of existing fencing panel to fill in space between gate and next fencing panel. 5. Take away any spoil or off-cuts All Stratco materials supplied by the Purchaser. Tradesperson to supply rapid set concrete and all tools and equipment. The gate is to hinge off LHS (as you look at photo) near the side fence, and open outwards towards the street.

PVC Fence to be installed, 8 metres on 1 side of house, which includes double gate and pedestrian gate. 1 metre gate to be installed on other side of house. Concrete only needed for the job. We have all the fencing material ready to go.

Two gates approx size length 5 and 10 feet’s

Needing a new electric gate supplied and installed. Looking for a gate that is full privacy eg colour bond. Currently have an electric gate but foundation of motor needs to be fixed.

Install one glass pool fence panel with 2 spigots into existing concrete footing. Install only, I will supply materials. Core drilled preferred if you have the equipment, or I can get base plated spigots. Panel to match height of existing panel.