Find experienced local fencing contractors in Birkdale

He have a colour bond fence and concrete sleeper retaining wall. When this was build the retaining wall should have been one sleeper higher. We would like to get advice if it is possible to rectify that. Take colour bond panels off Install one more row of concrete sleepers Put colourbodn fence back. I would need to know A. Is that possible to attach the new concrete sleeper on top of the old ones B: can we put the fence eback up without triggering council approval because if the total height. Photos are attached It is 11 panels 2.2 Meters each if I m not mistaken

Removal of existing damaged fence. Replacement of this fence with a 2.2m lapped and capped fence. Front fence built with 1.2m lapped and capped fence. 3 x 2.2m wide gates at 1.2m height

Supply and install fence approx 1 Metre wide and 1 Metre wide gate, both approx 1.8 high. Don't mind if its timber or aluminium

Nail with a nail gun, new pine fence pairings to old pine fence palings.

Hi, I’m getting some Aluminium picket fence panels ( 2035x900high) and pedestrian gate (1090x900high) and one double swing gate ( 2x1700x900high). I’m happy to supply all material ( Excluding boring holes and concrete), I need someone to install them professionally for me.

I’m looking for a fencer or handyman to repair a single Colorbond fence post that has come down. The post has pulled out of the ground. The rest of the fence panels are in good condition; I just need the post replaced or reset and reattached to the rails. I am located in Birkdale. Please let me know your estimated cost for a small repair like this and when you might be available.

I am replacing an old timber fence. I require a quote for a replacement fence in colourbond. The fence is 31 metres in length and is 2.1 metres in height

Existing fencing is being demolished next week. Approx 170m of temp fencing will be onsite and needs go be erected. I'm not sure exactly what day demo is happening so some flexibility is required.

Provide and install cladding to colourbond fence - approx 6m

Hi there We have 12.5 Meter length Colour Bond Fence and we would like to install an 300mm extension on top of it. I would need your assistance in purchasing the right material and then to get the job done.

Two large metal gates have been damaged in high winds and at least one will need replacing.

Install new soffits (eves) on one side of low set house, I already have the new materials to do, just need cutting to size and installing. House length approx 28lm by around 0.5m wide. Also some timber needs replacing only a small amount just to rot.

Put up baby gate, and build small pet Vida xl enclosure.

Replace side fence with colourbond Monument approx 16m.

We have a chain wire mesh fence that needs to be taken down asap as we have council doing some work

Assembly and Install stratco horizontal fence (18.5m length X 1.8m high) residential frontage. Inc. 5.8m driveway sliding gate (manual), 1m pedestrian gate and pair of swing gates for boat access. Install carport - no slab required, 3m X 6m Reduce size of garden bed + reinstate garden edging using sleepers (less than 1m high) X 4m length.

Existing fence and gate to be reinstalled. Around 9-10 meters of straight aluminium fencing to go in. Happy to answer any questions.

Installation Doubles swing gates 2x2

Need to puppy proof a fence. A board is needed at the bottom of a gate and at the end of the fence line.

Approx 30m fencing with a 2 gates required