Find experienced local fencing contractors in Marrickville South

We want to improve the privacy in our home by installing some trellises to our colorbond fence - probably 3-4. It would need to be mounted on something from the ground or attached to our side of the fence. I have marked in red the height which the trellis needs to sit to block the view from our neighbours. It needs to be reversible in case the fence is replaced at a later stage; not sure the best way to do this but open to suggestions. Please see our other jobs listed as they can hopefully be all done together!

Please provide quote for supply and install colorbond fence 8 m long

Fence has fallen over onto a public Park, needs to re-install and removed from the park as soon as possible

Wooden Fence in backyard - on boundary. 1 side only about 7 metres long. Removal of old fence (only the trellis side to be removed - see pictures) as well. Front wooden fence in front yard - both boundary sides. around 3 metres each side.

Replace pool gate lock in back garden

Looking for someone to paint the outside wall of our house. Wall has been water blasted and ready for paint. It’s about 5x2m and accessible without a ladder. Paint will be provided. Some other small touch up spots as well, and the back of a gate.

Repair front wooden picket fence and gates.

Milwaukee rattle gun CIW12 works off and on need to get it repaired

Remove ad place new timber

Street parking and side access to remove timber panels and metal stakes. Some timber fencing panels do have exposed screw/nails.

I need someone with a nail gun to repair timber fence. You need your own tools! - Due date: Flexible

I have had a new fence put in. My neighbour's side is higher than mine and there are gaps under my fence. I would like someone who can come and install an edge under the fence line. Tidy up the garden beds. - Due date: Flexible

Scope as below: -Supply and install new Colorbond fencing on side(10m)and the back(3m) -Supply and install a new Colorbond sliding gate(non-automated) (3m) -Demo,remove and dump existing timber fence at the back(only) Colorbond fence and gate must be standard sheet, 2.1m high, Shale Grey color Posts will be grouted at side and bolted to kerb at thr back Tree stump will be removed before this work starts - Due date: Before Sunday, 21 January 2024

R & r paling fence with colourbond 29m long x 1.8m high

Our colourbond lattice fence needs a gate installed. A post will need to be drilled into the tile of the patio. Please advise if a gate needs to be purchased of if one can be made from the existing fencing. - Due date: Flexible

We have purchased a new side gate, and need it installed. Posts are existing in the spot, but need to be removed and replaced (to the appropriate width to make the new gate fit) as they’re rotting. Must supply, posts, hinges, latch, and all tools needed to get the job done. I will stain and oil gate and posts. Gate hole (from wall to fence) is 1180cm width. New gate is 90cm width. Old gate was 1m width fyi. - Due date: Flexible

Brick fence segment fell, some old bricks still there. Need to relay and cement fence segment - Due date: Flexible

Due to significant rain the panels on the gate have swollen and is causing the gate not to close. We require: Wood panels from gate to be removed (we’ve removed a few already) Sand and re-stain all wood panels Trim the 4 wood panels that are causing the gate to no longer close (approx. 1cm trimming required) Refit wood panels to gate Install new lock (provided) to gate n.b. a few of the panels have stripped screws. - Due date: Flexible

Front brick fence which is built onto concrete slab for demolition and removal. Dimensions are 240mm thick throughout, 670mm high with 6 X 720mm pillars. Total length of fence to be removed is 11 800mm. White concrete pillar section between columns, half to be disposed of, half will be kept at the property. Ground level, no access issues, wide street with no parking restrictions. Parking in front of property or in front yard (could fit light truck) - Due date: Flexible

We need a wooden slat fence installed to sit in front of an existing colorbond fence - there is currently a bamboo screen that needs to be removed (it's tied on. Photo 1 is our fence on the other side - this is what we're wanting with a 0.5cm gap in-between the slats. Details are: - Treated slats, but not stained - Dimensions (approx) 10m in length - We need a bit of space in-between planks - approx 0.5cm - There will be two heights of screening: * 1st section 2.1 high from ground (this section will sit in a garden bed - see photos - so you will need to allow for longer timber to anchor to bottom of bed, approx 0.6m) * 2nd section 2.1M high, to sit on a level concrete path Please quote for all materials and installation. Thank you. - Due date: Before Thursday, 29 September 2022