Find experienced local fencing contractors in Darwin

Existing chain link gate is 2600mm wide and is double opening on hinges. Want the gate to be made wider by 1000mm. Job/quote to include * relocation of fence post on one side of gate by 1m - fence to be properly finished to post in new location * supply & install new double swing gate * reuse of existing hardware where possible (hinges/latch) Eventually we want to replace the manual double swing gate with an motorised/electric single rolling gate, so this is an interim solution - we are looking for the lowest cost to make the gate wider with similar level of functionality/quality as the current gate

Putting up a temporary fence to enclose a couple of dogs

We need to create an enclosed area for our chickens and add some protection over the existing coop. Here’s what’s required: 1. Build Two Mesh Fences * Construct two mesh fences, approximately 2m by 3m each to enclose a section between two existing stable fences. * The mesh fences will need to connect to a central support post for stability and to serve as the joining point * One of the mesh fences should include a small gate to allow easy access to the coop. 2. Add Mesh Water Protection * Install mesh cover over the small chicken coop we already have, to provide some water protection (e.g. from rain). Needs to be secure but allow airflow. Materials: - All materials (mesh, poles, gate hardware, etc.) will need to be sourced from Bunnings or a similar supplier. - Please keep all receipts — we will fully reimburse the cost of materials.

I need pool fencing installed in two small areas for pool compliance (AS1926.1–2012). Scope of Work: • Area 1: Install 1 gate + fence panels with posts. • Area 2: Install 1 gate with posts. (-possible area 3 to discuss ) Compliance Requirements: • Fence/gates must be ≥1.2 m high. • Gate(s) must be self-closing, self-latching, swinging away from pool. • Latch release ≥1.5 m high. • Gaps <100 mm under/through fence. • Posts set in concrete footings or securely fixed into solid masonry. • Install must pass NT pool safety inspection. I will provide: • Site access. • Can supply panels/gates/latches from Bunnings. You need to provide: • Tools, fixings, concrete. • Experience with pool fencing installs or compliance work. ⸻ Job Location: Budget: $1000 (labour only, depending on complexity & materials). Please quote. When: ASAP (need compliance before wet season).

Weld color bond fence post that was cut Bolt back on another fence panel that was taken off

660 metres property 22m wide and 30m long. Fencing will be around 22 m on both the sides and front around 7m.

I need someone to build and install an awning. I have steel available for it already, just need the frames built and installed. I can order the Colorbond too. I have attached a photo of my neighbours awning and basically want to get the same constructed. I can help with labour to install, I just don’t have the facilities to cut and weld the steel.

Install a shade screen on fence

Remove existing pool fence and install new fence. Fence has 2 sides, measuring roughly 14m and 9m. Existing is metal and has bolts into masonry securing it. I will buy new fence to install. Not sure how long this will take and so not really sure on the price.

Trying to attach a dog proof fence to side of house - it is either stone or brick. I do not have the tools to do it properly and dog continues to escape. Urgent

Rental unit with small dividing fence pickets need replacing , fence may need steel support replaced if rusted, also needing new gate latch to garden gate.

I need help to dog-proof my backyard. There is a small gap between the house and another (wire) fence that needs closing. The fence is approx 2m long, and must be at least 1.8m high. Timber fencing preferred, but flexible. Would need you to source your own tools and fence posts and I can pay a fixed price. Thank you!

I need help patching up holes in fence as dogs are getting through to neighbours yard. Chain mesh could work, but ideally colourbond laying lengthways so they can’t see through would be best. Need to drill holes to fix to fence line. Need done asap due to dog Fight

A old pool fencing that is bolted into ground that needs to be removed. Over the years the bolts that hold the gate down, require the right tools to do the job. Getting paving done in the area hence the timeframe.

I have community standard pool fencing, i.e. self-closing mechanisms on all external doors of my house and gates that face the pool. Most of these have been disabled and I need them reinstalled to rent out the property.

please provide a quote to replace 4 small sections of fence

The barrier fence has deteriorated due to age and needs replacing. It is around 15 metres. A gate is also needed.

Need a handyman to install backyard fence, materials will be provided. Please contact for more details.

Hello, I'm looking for someone who can fix a 2 bamboo screens to a fence. Screens are 1.8m high in rolls of 3m

I have an existing chainmesh fence, about 10 -11m long, 1100mm high, no top bar, top and bottom straining wires. I need its height extended to about 1600mm - 1800mm height, so that dogs and people cannot easily jump it. No need to remove existing fence structure, no concreting. Please let me know if this is something you can help me with and when.