Find a local electronics repairer in Glebe NSW

Interior plywood kitchen benchtops and external timber breakfast bench require resurfacing and refinishing. See photos.

Flashing red light and beeping sound when plugged in

The ceramic plates are not as hot as before and the red light alternating with a beeping sound.

I need to remove old and install new basin taps in the bathroom. Hardware provided.

Stop water flowing into bowl. Remove broken buttons. - View all the details of this offer: https://www.airtasker.com/offers/01K876JEWNAKDZXH64SVBPRW17

Replace cartridge in kitchem tap Two outside taps replaced Shower head replaced Remove water stoppier in bathroom sink Re fit a cartridge in kitchen - we have the cartridge We have the taps and shower head. Must be licensed plumber. Images supplied

I need to move a tap so it’s easier to reach, install a tap in the garden and one in the back passage.

Install Xbox to smart television

Bumps and dents and slight chips from bed head to be sanded down and colour matched from the rest of the bed.

Tap is dripping in the bathroom and needs new washers

Timber kitchen benchtops need resending and new varnish

Car battery's dead. Need a jumpstart

The tap connector came away from the wall and has been reattached but It's now leaking needs fixing. Have had to turn off the water.

I need to replace my old head unit with a new one. The new set up also has a reverse camera on it. I’m fitting it into a Mazda 3 bk 2008 model (hatch). There are reverse sensors installed on the rear and need to make sure these still function. I will supply the head unit and the reverse camera.

Six taps in my unit need attention. Dripping or too hard to close. Two basins and a shower.

Three rubber tree trunks need to be removed from a small courtyard and then the soil evened out ready for pavers. Should take approx an hour... can provide green bins to dispose of them.

replace leaky tap, plug another, replace shower head and disconnect washing machine. All parts except tape available.

Dismantle single bed ( 8 screws) and take bed and mattress upstairs for storage

Have very thin 40cm copper pipe things and they have these small thin no more than 2cm squared around the pipes I need to strip it for the copper and I need a big wrench and WD ,40 to remove a couple imof brass fittings They are air conditions and I have to remove the casing with a drill and remove what they call radiators and these have longs thin copper pipes that have the aluminum around them that needs to be cut so the copper is on its own and need a wrench to remove the brass fittings for scrap, I’ll help have 3 aircons that need the case removed the radiator popped out and grind the aluminu of several of them Radiators

Metal door stops need to have holes plugged and repainted. 8 holes and 2 additional small areas of damage. I have the paint, you'll need putty or something to fill holes, and all other tools to patch/paint. Cheers Required tomorrow, Sunday 3rd March after 2pm.