Find a local electronics repairer in Croydon VIC

- to replace our kitchen sink and tap - to replace our laundry tap The new sink is the same size as the old one, so shouldn’t need to cut the stone top.

I have a tap that keeps leaking even when it’s fully turned off. The water is dripping continuously and might be due to a worn-out washer or internal issue. Looking for someone experienced in plumbing to fix it. Please bring necessary tools or parts.

Details added in previous section

My last move see the removalest chipped my table and hoping to get it fixed

My GHD has stopped working, fuse might be faulty, have dismantled it but unsure what to do from here.

I need 2 leaking mixer taps replaced

As for my two-storey townhouse. I recently noticed a small amount of water pooling on top of a ceiling fan on the ground floor (see attached photo). The ceiling itself shows no visible water stains, marks, or damage. The fan is located directly underneath an upstairs shower area (not a bathtub or toilet). I suspect there might be a minor leak from the shower drain or waterproofing and water could be slowly seeping down along the fan pipe. I’m looking for a licensed and experienced plumber to fix the problem.

Fix internal wall for the whole room with gypsum wboard

Plumber to re-install new shower set & two basin taps

2 X floor lamps with faulty wiring. Both purchased for less than $50 each on Facebook market place. One flickers intermittently, the other gives you a tingle when you touch the switch/pole. Not sure if they're worth fixing, or just purchasing a brand new lamp.

Need new hdmi port on Xbox series x

Bent/broken pins on hdmi port for Xbox series x Needs replacement

I need someone to attach a door stop, re fix 2 more, hang a few wardrobe hooks, and finish around the outside of 3 windows (size 3x2m ea and 1 front door (1.8x2.4m) that have been rendered with beading or some kind of finish.

Most likely enough work for a full day Looking for someone handy with paint, patching, cleaning off paint from door handles trim, plane a couple doors, fix fence paint with spray in a few patches, paint air way vents after a render, attaching a couple door stops, attaching clothes hooks in walk in robe All the jobs are pretty tiny and just final details for the end of a decent Reno. Exact things we need are as follows; - paint 14 air way vents around the outside of a house (we got house rendered so they need to be the same) - attaching clothes hooks to our walk in robe x 4 - scrape any paint off bathroom sliding door handles x 3 doors without scratching - scrape paint off trim in 2 bathroom without scratching (minimal to do here) - fix 2 door stops- they’ve come loose, and attach 1 new ones - few few small spots around the house with paint or filler- approximately 8really little patches no bigger than 5x5cm - spray a few patches on the fence to fix up - mostly done but some patches need to be redone - attach a small shower shelf into a shower niche - attach a door to the access hole for under the house- needs to be purchased Also have one more job to attach some board to the side of the house- 2m x 3m but not sure into required extra time

HDMI port in PS4 is playing up and needs repairing or replacing.

I have a small unit, need exposed aggregate paving to front porch approx 2sqm with steps.

I want to put q new power point on top floor of my town house, also my Garage lights needs to be fixed.

Purchased ta GPS tracker for my car listed below are details of GPS tracker and the vehicle it needs to be installed in: GPS tracker: GTKPRO2 (GATOR) Vehicle: HONDA CIVIC 2018 (10th GEN) hatchback auto transmission I'm located in Croydon but am more then happy to drive to you! I have all the tools needed for the job, from multimeter to wire stripping pliars and everything else! I would also like to hang around and assist so that I can gain some knowledge

The lights on the porch with the Clipsal Infrascan Outdoor Motion Sensor aren't working properly. When switched to sensor mode, the lights start flashing instead of turning off when no one is around. Please provide a quote to repair this sensor or replace it with a new one. Thank you!

Need 4 stumps either removed or cut down to level with the ground. Each approx 25cm diameter - 2 approx 20cm, 1 approx 35, 1 approx 25