Find a local console repairer in Sutherland Shire

Looking for an experienced carpenter or deck builder to completely remove and replace the outdoor timber steps/tiered seating shown in the photo. The existing timber structure is old and damaged, and I do not want it patched or repaired. I want the timber section removed and rebuilt/replaced properly. The job will include: * Remove and dispose of the existing timber structure * Supply and install new suitable outdoor timber * Replace/rebuild the supporting frame where required * Recreate the existing stepped/tiered design * Ensure the new structure is strong, level and safe * Finish/paint in black to suit the existing area * All materials, labour and rubbish removal Location: Bangor (near Menai) NSW

I need 3 taps replaced, one shower head replaced and one shower mixer replaced. All have existing taps it’s just a switch over. Need done Friday as one tap is leaking.

Some small stumps to grind and potentially 1 small tree/ stump as per photos

Install lights, no electrical adjustments required, but the lights attached to the wall, and an extension cord attached along the wall

The tracks or guide rails may be slightly misaligned, because my roller garage door keeps getting stuck halfway. How can I fix this, and what would it typically cost?

The steps on the Nappy change stairs broke as more pressure was applied to it. If someone could come in and drill the nails back in place and make it more sturdy today. Thank you.

I need 2 green tree stumps cut close to the ground as possible due to back problems I’m unable to do it. it’ll be 20-30 min job if that just cut stump an possibly cut in half an leave it will post picture later there wide from right to left but skinny from front to back

Hi, I have two mixers and two taps I'm looking to be replaced/installed in my bathroom. Water will be shut off in my complex from 10am on Monday so would like for the work to happen during this time. Thanks. Andy

Fix leaking taps - 2 X garden, Bathroom basin, kitchen basin Replace bathroom basin cover plate

Take of broken clips and replace with new ones There is around six that need replacing

My car is parked on the Kingsway at Caringbah.It is parked on the hill on the side travelling towards Cronulla.About 50 metres down from Caringbah station.So it's in a difficult position for a jump start.Yet this is what I need as I have a flat battery.Can anyone assist me to get my car started?

We need someone that can demolish/remove the kitchen tiled splashbacks, kitchen benchtops, sink, kitchen island top/waterfall, without damaging the existing kitchen cabinets. (Please see attached photos). We are doing a kitchen refurb and keeping the existing cabinets, so it's important to remove the above carefully, without damaging the kitchen cabinets and structure of the island. Skip bin organised, so no rubbish removal needed. Please send your quote, trade qualification and availability. New stone is getting installed on the 24th June, so the job has to be done prior, ideally closer to the date.

Looking for an experienced tradesman or carpenter to inspect and quote on sealing gaps throughout my home. The task involves caulking and sealing gaps between timber floorboards and skirting boards across four bedrooms, as well as other areas of the home, where required. This task is for an in-person inspection and quote first, with the potential for the work to proceed shortly after. Please bring experience with neat, professional caulking and finishing work. No pics, so please don’t request any. Happy for you to accept the task to discuss further. Thank you

Change washer on 4 bathroom taps and supply washers

Need walls and skirting boards patched up (photos attached)

We are in the process of doing a small renovation on our laundry and need a plumber to lower two sets of taps for installation of a benchtop.

We are in the process of doing a small renovation on our laundry and need a plumber to lower two sets of taps for installation of a benchtop.

I will need 10 Tree stumps grinded in these planter Boxes

Hi, I’m looking to get 3 sets of taps fixed. I had a go at repairing them myself, but the bottoms are on an angle which made them difficult to remove. I believe they may need new washers — 2 of the taps are quite hard to turn on and off, and the other just keeps spinning and won’t tighten or stop turning. Please let me know your availability and a rough idea of cost.