Find an experienced builder in Broadway Nedlands

Basic model, no electrics or side panels. To be installed on level deck. Just wanted to get an idea of how much it would cost . Cant take pics at the moment, sorry. Deck is level. I will post more when I can! Was hoping to get it done in about 3 week's time. Thanks!

Assembly of Pergolux pergola on deck

Stratco HM9 garden shed installed on a concrete slab, slab will be down already. No power req 3.6x2.1x1.9 sizing

We plan to get a large pergola, (well, in fact, three connected pergola areas), in our backyard. The structure would need to be attached to the house, either through a flyover system or by attaching to the fascia. It is a flat skillion roof sloping upwards (away from the house) so gutters and drainage are an issue. We have found a carpenter, but they require drawings showing exactly how this would work, ( in terms of the existing roof/rafters/beams etc.) to work from. I need an architect/draft person/builder who can do this so the carpenter knows exactly what to do. There are a couple of ways it could be achieved and need someone to look at the house to work out the best way to complete this. I have included a few pictures. The last is of the existing backyard. Three are computer generated concept drawings giving a rough indication of what it would look like (we have made some changes since then, but it gives you an approximate idea). The first is a hand drawn plan showing dimensions. I do have full house plans, and plans suitable for the council(deed to comply) available. BTW , as you can see from the photo of the home as it is, the existing goal in the center would be removed as part of the project. Someone with a builder’s license, I.e. A registered builder,prepared to submit for council building approval, would be ideal.

The pergola is overgrown with ivy. On one side there is a 153 m wall and bricked structures holding soil from which the ivy grows. There is a colorbond projection/roof from the house which is supported by 2 wooden posts covering entrance to the house. This is to remain in place. The other 2 wooden posts that support the pergola are to be removed along with all the ivy and the pergola itself. The posts are secured with metal brackets installed in the brick paving, and also need to be removed and made good with bricks (we have enough). Any ivy on top of the colorbond roofing, on either sides of the wall and in the brick garden beds needs to be removed entirely, including remnants of ivy attached to the wall. All rubbish to be removed. Some of the stems are very thick and may require a power saw.

Hi, After a quote to supply and install Patio. Please see images .

New Easy shed installation 3.75m x 2.25m Gable slider

Job is to remove old render, remove tiles and 30 mm of concrete to allow for proper screeding. And to remove all rubbish from the site. See attached photos.

High pressure wash, Lift existing pavings, use pave'n'lock, repair uneven areas, finish uneven area 40m2

We are wanting a complete back garden overhaul and not quite sure where to start. I’ve had some concept drawings done, but now I need to find someone to build it. It involves pulling down an existing pergola and patio and installing new decking as well as paving as well as a pergola, (and we want a fireplace and an outdoor kitchen). Wanting a builder/carpenter/landscaper to help create this. I have included a few photos of the concept drawings as well as a photo of the existing garden (last one). I i’m aware the total budget is going to be a lot more than the amount I’ve put, but I just put that in as a rough indication of what some of the individual tasks may cost in case I do them as separate projects.

A small shed bought from stratco Needs someone to install

Prepare base, assemble shed, anchor shed on the side of the house

We are renovating our bathroom. We need someone to break the existing floor (tiles and screed, down to bricks). We also need to remove the existing plaster/rendering on the walls. Finally, all waste needs to be disposed off.

Pull down and rebuild pergola structure and install new roof sheeting. Supply labour and materials.

We are renovating our kitchen and laundry. There is a wall that we suspect is loadbearing and needs demolition. There is also a small tiny laundry cupboard which appears to be brick but we do not think this is loadbearing. We would also like to remove this as part of the demolition of the kitchen and laundry . Either going to knock down entire wall or just create a servery gap. We strongly suspect it is load bearing. Must have own insurance Will need a lintel/ beam spanning opening

I’m about to embark on a kitchen and laundry renovation with new tiles required throughout, I need to get rid of these Italian looking 70s tiles and also demolish the cupboards and remove securely the existing appliances.

Install 3m x 0.78m Flat Roof Shed from Easy Shed 2.12m high

i have pavers at the moment but i need someone to come and built p - Due date: Flexible

Hi Tazz, my hubby finally has the area ready (enough) he thinks and has started to put the shed together. Are you able to quote finishing the job? He has Father’s Day and a birthday around the corner so would be good to get it done

Repair of some sinking/moving pavers on driveway and patio. Will take pictures tomorrow.