Find a local brick fencing contractor in Inner South Melbourne

Repair loose brick and cracks

I’m looking for someone with an eye for detail and necessary tools to install new house numbers on our front fence, as well as remove the old numbers. Refer pictures to see the current numbers on our brick fence that will need to be removed, as well as the new numbers we wish to have installed.

Front brick fence has been rebuilt and rendered. It needs to be painted to match existing colour. Paint will need to be supplied or purchased. I have 2 litres but don’t think it will be enough. Would be ok for undercoat.

patch and repair external brick fence paint (peeling paint) and apply new paint. Approx 15m of fence. Paint both sides.

Sloping front brick fence, exploring any options to fix/straighten

Demolish brick fence on two sides of the block prior to house construction begins. You will remove the entire brick fence and take away demolished brick. Clean and tidy up the site. Please provide quote to get the whole job done. See attached the site photos.

PLEAEE SEE ATTACHED PHOTOS PLEASE QUOTE ALL INCLUSIVE PRICE. Cut and remove 2 sections of brick fence to allow vehicle crossover to connect to driveways. There are two sections of the fence to be cut and remove as follows: 1. Section 1 is half removed. You will remove the rest of the marked section then construct a brick pier on either side of the removed section of the fence. 2. Section 2 of the brick fence is very low. Remove the marked section of this fence. Then construct a brick pier on either side of the removed fence. Remove bricks from top part of the fence to make the maximal height to be 1.5m. You will bring and use your own equipment. The site must be cleaned up after you are done. Please quote only for the entire job and no hourly rate offer.

As before - brick fence to be built in Black Rock

Build a brick fence. Footing will already be in place. Piers need to be core filled.

We had someone damage our short brick fence and two front pillars, we need this replaced and fixed, with same bricks to match rest of fence.

About 10m length brick wall fence footing -concrete job

Looking for an experienced bricklayer / concreter to demolish and rebuild 2 x structural brick fence piers to a specified brief. Scope of works: Knock down and remove 2 existing brick piers Excavate and construct 2 new reinforced concrete footings. Rebuild brick piers and core-fill as specified Pier dimensions (each): 1500 mm high 360 × 360 mm Footings (each): 800 mm deep Pad size to suit pier (approx. 600–700 square) Concrete: N20–N25 Reinforcement: Reinforced footing cage, N12 deformed bar, 4 vertical bars, N12 closed ties @ ~200 mm centres, Minimum 50 mm concrete cover Steel posts: 1 × 100 × 100 × 4 mm galvanised SHS per pier. Post embedded 600–700 mm into footing. Post tied into reinforcement cage. Posts must be plumb and set before concrete pour. Pier construction: Brick piers built around steel post. Core backfilled with N20–N25 concrete. Brickwork tied to steel post. Piers to be square, plumb and ready for future gate automation Important: Structural steel carries gate loads — brickwork is non-structural. One monolithic concrete pour per footing. No dynabolting or post-install chemical anchors Access: Good Start: ASAP

Replace metal edging and render brick fence ready for painting

The corner of the brick fence 2m high was damaged (see the photo). Metal angle and the render is to be reinstated and then painted in monument colour as the rest of the fence.

A part of the fence including the postbox was damaged, which needs to be reconstructed. Pics attached.

I have 4 L self priming white paint and a roller suitable for brick as well as some paint brushes. Just need someone to brush the surface clean and then paint. Front wall is 10.5mx1.85m, side wall 9mx1.85m and photo is of a third wall just needing some spots touched up.

We are wanting a 9.86 meter by 59cm brick front fence demolished and removed.

We have no front fence and want a brick fence to match same used on the house. Its roughly 15m length would like a brink fence built. Will need to level grass. Flexible with date

To build up brick fence with 3 x columns 1.2m high. Total distance: 5m. Fence and columns will be rendered, so the brickwork look doesn't matter.

The brick fence between me and my neighbours property has cracked and is leaning about half way up. There is a vine that is growing on it, which could have caused the issue? Need someone to secure the brick fence or quote on removing.