50 BMW Service in VIC

I need a backyard bmw savvy who can fix my car. It had left frontal collision with a poll. First i need an expert who can give me a list what needs to bought/brought and an estimate cost including labour.

Change Timing belt for 2012 bmw 328i , i will obviously drop the car at your shop. I really want it done professionally from a german car mechanic.

Looking for a qualified mechanic to repair a 2008 BMW 520d E60 with the N47 engine. The timing chain has failed, and the car was started after the failure, so internal engine damage may have occurred. I’m not looking to replace the engine — if needed, I would prefer a full engine rebuild based on damage assessment. Scope of work: • Replace timing chain • Inspect for internal damage (valves, pistons, etc.) • Rebuild engine if necessary (no engine swaps) • Job can be done on-site or at your workshop (Melbourne) Please provide: • A quote for timing chain only • A quote for full engine rebuild (parts + labour) • Timeline for completion • Proof of experience with N47 engines Budget range (guideline): • Timing chain replacement: $1,200–$2,000 • Engine rebuild: $3,000–$5,500+ (depending on damage) Car is currently not drivable, so towing may be needed if not on-site. Looking to get started ASAP. Please only apply if experienced with BMW diesels and full engine rebuilds.

I got front collision specially on passenger side. Left tyre position is different than right one. Airbags popped Windshield cracked. Might need to bring tools as I can't get my finger to open the bonet even.

I need a faulty reverse camera replaced in my 2009 BMW X5. I have all that is shown in the image attached.

Front discs and pads including sensor fitting to bmw f25 2011

I am looking to see if someone can fit a hard wired dash cam in my bmw x3

Replace the two front struts on a BMW X1 2017. Must be an experienced mechanic and have own tools including large jack, jack stands and tools to complete the job,

2000 e46 318i bmw, electronic fault within the dme diagnostic line, no obd2 connection or engine diagnostics on start up (no cel light ). Dme has been replaced and is not the problem. Constant excessive power drain from battery, seemly indicating faulty ground? (Battery is unable to start car within a few days of sitting) Dash lights checked Budget is flexible, especially upon successful fix Obvious fuses checked Wiring in good condition with basic inspection Obviously grounds checked for continuity

Need Help Installing LED Interior Lights (Hardwire to Fuse) – BMW 435i.I’ve bought the Type S LED Smart Interior Lighting Kit and need help hardwiring it to my 2014 BMW 435i (no S-plug or direct 12V input). I’m not comfortable with electrical work, so I need someone who can: Connect to a fuse tap or ACC source (wiring included in kit) Tuck and hide wires neatly Ensure it works with ignition on/off Budget: Around $150–$200 Preferred time: Flexible this week Please only message if you've done car wiring before or have auto experience. Cheers!

I would like someone to install a few modifications to my car including: 1) aluminium charge pipe 2) high-flow catted downpipe I have already purchased these parts. I'm happy to drop it off at a place nearby. Thank you

I have a 2009 BMW 120i (E88) with a confirmed fault on the Bank 1 Pre-Catalytic O2 Sensor (upstream sensor). I need a qualified mechanic to: Replace the faulty Bank 1 Pre-Cat O2 sensor (I will provide the replacement part) Check for any related issues that may cause sensor faults (e.g., oil leaks, exhaust issues) Provide advice on further repairs if needed Please bring your tools and diagnostic equipment. The car is located in Docklands, Melbourne.

I have a 2007 BMW series 335i hardtop convertible. The passenger rear window & convertible functions have ceased functioning. The sensors need checking & resetting. Tyre pressure, window & other alerts are not resolved. I'm open to quotes please. Located in Sunbury - can bring vehicle to you.

Car - BMW 325i 2001 - came with standard radio (not navigation so no need to run cable to rear of car). Instal Xtrons PX8446blhgs unit. no reverse camera, just head unit.

Looking for someone to supply and install a full set of LED underglow lights on my 2009 BMW 320i E90 in Malvern East. I want a clean install – lights on all four sides (front, rear, left, right), properly wired (ideally to a fuse or switch), not just plugged into the 12V socket. Prefer multi-colour RGB kit with app or remote control. Car is lowered slightly, so installer must be confident working with low vehicles. You must provide: Quality underglow LED kit (RGB preferred) All necessary wiring, tools, and parts Full installation at my location or nearby Budget: $220 total (parts + labour) – can go higher for better-quality kits and clean work. Show me examples of your work if possible.

My car got side swiped and I want the glass on my passenger mirror replaced and put back in. My max spend is $150 for the glass included which I don’t know how to source. My car is a bmw 2010 sedan 3 series 320i model.

Hi there, I’ve had someone let me down with completing a backup cam install into the Mr12Volt CarPlay unit they installed in my BMW E82. I bought the unit and replacement boot handle with camera, though my understanding is that it’s being powered by jumping onto the 12V reverse light when it needs to have dedicated power. It’s there — the screen goes blank in reverse but no image. It worked for maybe a minute or two (albeit really flickery) when it was installed but stopped pretty much straight away. He was meant to come back to fix it but has ghosted me and gone on to take other jobs. I’m looking for someone reliable and professional to: • Run dedicated power from the pre-installed Mr12Volt unit to the installed backup cam • Assess functionality of the front grille cam (cable already fed through firewall and in place — I have the front cam ready) • Replace existing backup cam in BMW F31 with a replacement cam I have (higher resolution) Needs to be neat and tidy please. Any questions, please ask. Thanks very much in advance.

I need my rear brake rotors, pads, and wear sensor replaced on my 2004 BMW 330ci. I have the parts, you will need a low profile jack (car is fairly low), jack stand, brake cleaner, and any other necessary tools.

Car key was left inside bmw car. And is locked.

Install and hardwire 2 VIOFO 229 pro in a 2017 BMW X1 and in an Audi S3 convertible. The rear camera of the Audi may be omitted if the installation is too complex or expensive. Dash cams have been purchased and awaiting delivery