Find experienced auto electricians in Sydney Eastern Suburbs

Looking for a qualified auto electrician to install and wire up an auxiliary battery system in a camper van. All materials are already supplied — just need the installation and wiring completed. What I have ready: • Auxiliary (deep cycle) battery • DC-DC charger • Power/distribution board • switches and usb chargers • Cabling • Lighting already wired/run through the ceiling • mini fridge • isolator Etc Job involves: • Mounting and connecting the auxiliary battery, DC-DC charger, and power board with all switches and cables installed to joinery and walls around the van. It’s not much. • Running an ignition-sense wire from the DC-DC charger to a switched (ignition-on) fuse in the van’s fuse box, so the charger knows when the engine is running and starts charging the aux battery. (Blue cable) • Wiring in the switches and existing ceiling lighting circuit • General check that everything is safely fused and connected correctly I will be around helping, I’m a carpenter and I’m building it myself. Please send a quote for labour.

I need some to install my eye modified fog lights/headlights on my motorbike MT09

Looking for dashcam installation for 2 cars- 2025/2026 Mazda CX-3 and Mazda CX-30

Nissan Pathfinder R51 (2008) AY93HP I had the car inspected for a pink slip, and all was good apart from the rear brake lights. I replaced the brake light switch, fuse, and right bulb. Now both the left and right lights are working fine. However, the high level light doesn't seem to be getting power so I need this looked at and fixed.

Viofo a229 plus Front and rear dash cam installation (hardwired)for parking mode in Nissan xtrail

mazda 2 2016 installing car head unit https://www.ebay.com.au/itm/356820516255?chn=ps&_ul=AU&_trkparms=ispr%3D1&amdata=enc%3A12pona-xZRHKnlXuORbt2nw43&norover=1&mkevt=1&mkrid=705-173151-935305-0&mkcid=2&mkscid=101&itemid=356820516255&targetid=2370046502538&device=c&mktype=pla&googleloc=9071792&poi=&campaignid=23951513933&mkgroupid=204376462744&rlsatarget=pla-2370046502538&abcId=10742538&merchantid=7364522&gad_source=1&gad_campaignid=23951513933&gbraid=0AAAAAD97CxQDREItFw4hU-pTybNUx04mp&gclid=CjwKCAjwsrbTBhAvEiwA0Bpp4Z9SYHA_AzSYDmE1EOzthgITsp4JYtGYkE_FfxcxcPwwjPZXlv1GaRoCOpgQAvD_BwE

Looking for an experienced, licensed panel beater / auto body specialist to repair front-end cosmetic and physical damage on a BMW iX. 1. Front Bumper & Grille: Realign dislodged lower bumper trim, repair front panel denting/scuffs, and ensure proper physical alignment of the front fascia. 2. Headlight Unit: Physically replace or repair the cracked front headlight lens assembly. 3. Paint & Cosmetic Touch-ups: Buff, polish, or touch up scratches on the side fender, mirror casing, and hood area. 4. Panel Beating: Smooth out any associated dents on the front panels to restore the original shape.

I have a 2016 BMW 118i F20 with halogen headlights. I’m looking for someone experienced with opening BMW headlights. The job includes: * Replace both outer headlight lenses (I can supply the new lenses) * One lens is cracked * Remove moisture from one headlight * Clean the inside of both headlights * Reseal both headlights properly with butyl sealant Please only make an offer if you have experience opening and resealing BMW headlights or have completed similar jobs before. If you have photos of previous headlight repairs, please include them with your offer.

Landcruiser new rear bar requires wiring of tail lights. Can piggyback off existing trailer light plug wiring. Cable lengths look sufficient to reach trailer plug.

Need a help of a mechanic for fix the latch of my Fonz Arthur 3 electric scooter. The seat of the bike is stuck and doesn’t open anymore.

**Please leave offers under OFFERS and not as a comment/question.** --------- Reposting as I’ve since moved house. Need someone to extend the trigger cable for my new reverse camera (it’s too short) and to splice/solder it to the positive cable of my reverse light. Will need you to please solder/reconnect my reverse light positive cable at the same time - I accidentally cut through it while attempting the job myself and now don’t have a reverse light 🤦 Should be a quick job for an electrician/auto-electrician 🙏🏼 Car is parked in the underground parking of my building which is easy to access/plenty of space to do the job.

Issue 1. Fridge automatically switching off after being turned on. Issue 2. Solar panel over charging leisure battery

Install car audio unit to sync with speaker, reverse camera , speaker and steering wheel buttons Car is 2011 Subaru Forester

I have aftermarket Alternator Denso style 70A 27060-16460 need someeone who can instal an remove old one

I need a Pioneer Aftermarket head unit - it has been purchased with the correct Aerpro bracket installed, along with a reverse camera in our 2009 Mark VI Golf.

Polish cloudy headlights Volvo xc60 Location maroubra

I need a drivers side VW electric wingmirror fitted

I need someone to install a set of Yakima roof crossbars on my Ford EcoSport 2018 (flush roof rail type). Either https://www.roofracksgalore.com.au/yakima-aero-thrubar-black-2-bar-roof-rack-for-ford-ecosport-5dr-suv-with-flush-roof-rail-2018-onwards-gp0261xdq or https://www.roofracksgalore.com.au/yakima-aero-flushbar-black-2-bar-roof-rack-for-ford-ecosport-5dr-suv-with-flush-roof-rail-2018-onwards-gp0276f30 (open to recommendation). The product above that I'll but includes the bars, the fitting kit and the instructions — I just need them mounted securely and correctly. The kit attaches to the factory mounting points on the flush rails, no drilling required. Should be a straightforward job for anyone who's done roof racks before (around 30–45 mins). Please bring your own basic tools (I can take the car if it's around Maroubra or Hurstville).

Hi, Looking for a car audio installer to fit a new 6.8" double-din head unit (Pioneer DMH-Z6350BT) into my 2014 Subaru XV. I'll supply the head unit and all harnesses (Aerpro CHSU14C + APP9PIO8). Also to fix wiring on the right hand side drivers speaker. Just need the labour. The install needs to retain: Steering wheel controls Factory reverse camera Factory USB Looking for someone experienced with Subarus who can wire it cleanly with no cut factory wiring. Should be a straightforward plug-and-play job with the harnesses provided. Located in Randwick. Happy for mobile install or to drop the car to you in the eastern suburbs/inner south. Please quote labour only and let me know your experience with Subaru fitments.

I have a Royal Enfield 650 Continental motor bike. 4 weeks had a new battery installed, fuel lines cleanedand petrol tank drained. Bike parked outside with cover. Did not ride for two weeks and now battery is flat! Need you to check that there are no leakages and may be install a kill switch to preserve battery.