Find experienced auto electricians in Randwick

Remove and replace headlight covers for Golf mk6 I have the new covers. Heat gun/ adhesive required.

Install and code new battery for 2018 VW golf 110 - start/stop battery BYO tools and OBD11 scanner

Can’t get the key in the barrel ignition of my golf 2009. I think it needs replacing

I have '07 Madza 2 which I believe needs a battery replacement. It is currently dead but I have jumped it yesterday and it turned on straight away and ran for a bit but when I tried to take for a drive, it cut out again. I need someone to come out and run a battery test and change the battery on same day if possible. Rego: BDX63E

SPY H1 Car alarm system installation on my toyota hiace super custom 1999. I already have the unit and the whole dash is already out for the unit to be installed. Van has a engine starter already installed.

I need my rear tail lights wired as I purchased a canopy which already has lights.

Airtasker Ad: Auto Electrician – Wire 2 LED Light Bars + Dash Cam (Ford Ranger 2025) Title: Auto Electrician Needed – Wiring Only (LED Light Bars + Dash Cam) – Ford Ranger 2025 Location: Randwick, NSW (on-site preferred, or I can travel within the vicinity) Vehicle: Ford Ranger 2025 ⸻ Important: Both light bars are already mounted – this job is wiring only. ⸻ Work Required: 1. Roof Light Bar – Hardkorr Hyperion 50″ Single-Row • Already mounted on roof rack. • Specs: High/Low beam, amber/white DRLs, 19.5 A draw on high beam. • Task: Wire into existing auxiliary switches (already run to under bonnet) and connect DRLs into car’s DRLs. 2. Grille Light Bar – IRONMAN 4x4 Bright Sabre Dual-Row 32″ • Will be mounted behind grille. • Specs: Dual-row, multifunction DRL/position light, 12–24 V, IP67 rated. • Task: Same wiring setup as roof bar, with DRLs connected. 3. Dash Cam – Rear External Camera • Main dash cam (2 channels) already installed. • Task: Run wiring for third external rear camera underneath vehicle and mount to back of cabin. ⸻ Installer Requirements: • Must be experienced with 4×4 wiring and dash cams. • Provide neat and secure wiring (proper connectors, heat shrink, tidy routing). • Able to work in Randwick, or within surrounding suburbs (I can travel if needed). Please include in your response: • Relevant experience. • Availability. • quote for labour only.

My 2.5 year old Electrolux vacuum cleaner (otherwise in very good condition) stopped working a couple weeks ago and wouldn’t charge, even though the charging lights would light up while it was plugged in. I ordered a new battery online which initially fixed the issue. But after turning it on a few times, it wouldn’t turn off - so I had to unscrew the cap and remove the battery. Since then I can’t get it working again, even with the new battery.

I need help with the electrics on my camper trailer. The system isn't charging from either Anderson plug with the car, solar panels via an Anderson plug or 240 volt input. Is this something you can help with?

Triton Mr 2019 model, have a bonnet mount for up near the windscreen to be fitted on

dash cam installation front and back with already purchased new dash cam, needs to be wired to the car etc

Rectify old 4wd wiring badly installed in 2007 JK wrangler Ideally rectify old driving light wiring; reverse / front camera, rectify duel battery connectors and relocate control box for ausbeam system Find earth leak Internal light not working A lot of small pieces of work to be rectified If extra work will pay hourly rate over and above offer

I've bought a front and rear dashcam online and what it installed in my 2022 Toyota RAV4

Window switch has come loose from housing

6 months ago my car was displaying a message saying engine overheating. And the engine was making far more noise than usual, even when stationary. I brought it to a mechanics (I have the diagnostic report). They said they didn't feel comfortable guessing the fix as they weren't 100% sure of the issue. They advised getting it assessed by an auto electrician. Their assumption was that one of the sensors was acting up / mis-signalling and causing the car to enter limp mode / overheat. However, whatever they did fixed the issue. No problems for months. The issue has returned this week. Car: Skoda Octavia, 1.4L Wagon, 2015

I need someone to install/fit my daughters car seat in my car. It’s a forward facing Britax car seat.

I am installing an off-grid electrical system in the canopy of my 4WD. I need a sparky to do some connections for the 240V section of the system. - I have a CMS inlet and lead already installed and I need the other end of the lead connected to an installed GPO in the canopy. - I need 2x 10amp 240V leads shortened and terminated with standard 240V plugs (supplied). Pretty simple job but I'm not allowed to do it so need sparkly to make the connections. - Due date: Flexible

Our car has a parasitic drain on the battery, this causes it to need a jump start if not driven for a couple of days. - Due date: Flexible

Holden astra 2008. Reverse camera installation required. Thanks )

Car needs light bulb change - Due date: Flexible