Hire a trusted appliance repair service in Nunawading

I have an Impulse ECE5 elliptical cross trainer located in a small personal training studio in Reservoir, Melbourne. The machine powers on and the resistance works normally, but the display screen is blank and does not show any information. The buttons respond and the console beeps, but the screen does not illuminate. Looking for someone experienced with gym equipment or elliptical repairs to diagnose and fix the issue. It may be related to the console display, backlight, or internal wiring. Photos can be provided if needed.

My GHD Straightener flashes red and beeps. Seems like the heating element is not working. Please help me fix it. Thanks.

We have got a Bellissimo oven that has recently started to behave inconsistently. No matter what temperature or oven setting we do, the oven burns with a very high temperature and burns the food. We would need an Oven-technician to diagnose the issue and suggest how to fix this.

needs balancing and making sure it is levelled to prevent it from excessive vibration during drying. Access is challenging to do it without some tools to lift the machine and level it and check the levelling.

Fisher and Paykel. "Fresh 5.0" Smart Drive 9 top loader. Is leaking and not spinning well after cleaning it.

My Electric blender will not turn on,

I have MSI RTX 3090, and one of the 8-pin PCIe power connectors is burnt/melted. The GPU still works, but the power connector is damaged and may need cleaning or replacement. Please refer to the image.

LG Dishwasher holding water with error 0E The LG Model type is LD-1485T4 Need someone who has experience in fixing this issue and have the dishwasher operate normally.

I have a working ecobee smart thermostat that controls the heater (just gas heating, not cooling). It has been running just fine for a few years. However, it stopped working just recently. Could be related to a recent power trip but not sure. Need an electrician with experience in smart thermostat.

Fisher & Pykell dishwasher stops with U1 error code after roughly 10 minutes of runtime when running top drawer. Bottom drawer works fine. Working spare same model is already on-site for parts. Task involves diagnosing issue and swapping out working parts as needed. Make: Fisher & Pykell Model: DD60DCX6 Photos attached.

The spin function is not working . Possibly fanbelt has gone.

1. Washing machine is giving UC error. When did troubleshooting it says 9E1 error. Might be related to voltage. 2. Machine vibrates during the spin.

Replace rubber on front loader bosch machine

I have got a rainwater tank pump that had stopped working. I tried restart, power on off and everytime after turning on, it goes to the "failure". Don't know where the fault lies, need someone to check and fix. - Due date: Before Thursday, 21 December 2023

Electric roller shutter stuck - Due date: Flexible

Lg washing machine rubber seal and metal ring get loose, causing water leaks - Due date: Needs to be done on Tuesday, 13 June 2023

heating did not working since last week - Due date: Before Friday, 19 May 2023

Hi, I need someone to fix a Solar Skylight. No electrical work required. 1) Go up to roof to mount the solar panel (small) 2) Cut ceiling at kitchen 3) Connect the cable 4) Mount the Skylight Probably 30mins - 1 hour work Thanks - Due date: Flexible

Hello, the 3 prong connection on the electrical cord plug in has been damaged and one of the prongs removed on my washing machine. I need this repaired to continue using my machine please! It fused/melted in the power point so unsure if there is any further damage to the connection. Thank you - Due date: Needs to be done on Wednesday, 22 February 2023

Freezer is cool but fridge isn’t. Don’t see much ice build up and the fan isn’t working. Nothing is obstructing this. - Due date: Flexible