Find a professional tv antenna installation service in VIC

Hi I need the antenna removed along with any wires for a cleaner look. The birds often sit on it and poop on the solar panels. I’d like the bird poop cleaned off too if that’s ok. You can leave the antenna and wires on the lawn. Thanks

We need a new tv antenna and three points

I need an antenna and 3 antenna points installed. The house is new and no plaster.

I bought Uniden UHF radio and antenna recently ( photo attached) Need to install to my 2019 Mitsubishi Triton Also please need professional finish

Wall plug installed for tv aerial

Shark type car antenna on honda crv 2013 cap dislodged and screws broken

Need to move the power outlet and TV antenna outlet to a different wall in the room

We have some old antenna poles left on the walls near the roof. Birds perch on them and mess up the deck below. Need help to either remove/cut out these poles or install bird spikes. We also have cat netting in the way that needs to be removed and put back to access the poles. The poles are a bit high up about 5mts off the deck and I don't have a long enough ladder. Budget is indicative, please submit your quotes.

Need TV roof antenna installed with 2 connections points in house. I will supply all the material from antenna, RG6 quad shield coaxial cable and all fittings required. Just need installation only

I need an installation for a tv antenna on a flat screen tv

My reception of ABC and Channel 10 is poor, most times I can't see the channels at all, include when re-tuning the TV. I also tried a signal amplifier from Bunnings but that didn't make a difference. Currently, without the amplifier, I was able to get ABC back after another re-tune, but Channel 10 still didnt get found. Would like an experienced antenna tech to measure the quality of signals and give a proper diagnosis. I suspect resolution may require getting on to the roof to check the antenna or cabling. Please let me know if you need any further details.

Hi, looking to have antenna removed as no longer required. Access is from second level on other side of house. Roof is tiles with pergola below antenna.

Job involves: * Powerpoint: Re-seat/secure the existing double power outlet back into the wall mounting bracket. It is currently loose/out of position and appears to be missing screws. * Antenna outlet: Replace/reinstall the existing antenna wall outlet/connector so it is securely mounted and sits flush against the wall, as shown in the reference photo. * Replace any missing screws/fasteners required for both outlets. * Ensure both outlets are properly secured and functioning safely. The photos show the current condition and the desired finished appearance of the antenna outlet. Looking for someone who can supply any minor parts required and complete the job in one visit. Budget: $200 depending on parts required

My TV aerial has become loose through storms. I would like to someone to screw it on so it’s solidly adhered to the roof.

Hello, I have moved into a new house and need to install the TV antenna. I have purchased the antenna and mount from bunnings but need assistance installing. Not sure if a splitter is needed etc. Very easy access to on top of roof from balcony. Please let me know if you can assist!

Roof leaking in laundry and front entrance and antenna fallen down needs to be screwed in again ,sliding door needs new lock to be put in and wood needs to be put around one window and sliding door

2 houses only 500 meter away from each other one is double storey other one single storey l need both houses to install antenna

- Two power points moved approx 400mm to the right on the same wall - Antenna socket to be disconnected A wardrobe is being fitted to this area so no plastering of the old holes will be required.

Apartment is in Grey Street East Melbourne The TV doesn't seem to get live to air TV Not picking up channels when I scan the TV Looks like it's all connected

Looking for an experienced auto electrician/car audio installer to advise on and install the following in a Toyota Prado 120 Series: • Apple CarPlay head unit – happy to purchase myself based on your recommendation, or have you supply • Reversing camera connected to the head unit • CB/UHF radio aerial and required mounting/wiring • Any necessary fascia kit, wiring harnesses, antenna adaptor etc. I’d like a neat, professional installation with all wiring concealed. Please let me know what you recommend, whether you can supply the required parts, and your installation price. Happy to discuss the head unit I’m currently considering (Kenwood DMX7525DABS with CMOS-150HD camera).