Find a professional garage door installer in East Melbourne

My rolling garage door is not working and currently has to be operated manually. I need someone to inspect it, identify the issue, repair it, and supply any parts required. Please provide an end‑to‑end quote covering all materials and labour.

Garage door spring snapped Needs to be replaced

Details -Door type: single tilt door (standard size) -Condition:The door is app.40yrs but currently operating manually. -Scope of work:1.supply and install a reliable brand motor (eg. Merlin Tiltmaster or equivalent) suitable for a tilt door. 2.Conduct a general service of the existing door (lubrication and spring tension adjustment)to ensure it's safe for automation. 3. Program 2-3remote controls. -Power: There is a power point near the door. Requirements; -please have prior experience specially with the tilt doors. -The door must be tested for safety after installation. -please provide a warranty for the motor and workmanship. Looking forward to your quotes Photos of the internal mechanism are attached.

Hi, I’m looking for an experienced garage door technician to repair an Automatic Technology Australia (ATA) garage door opener. Issue: • Motor runs normally • Chain does not move at all • Door does not open or close • Red & green lights flashing (likely overload) • Suspected stripped or failed drive gear / sprocket (common ATA issue)

Right side screw is out. Door is imbalance and can’t operate now

Can you help garage roller door paint in Burwood east? Just need the roller door painted without spraying walls or the floor. About 4m length single story house. Thanks

When closing, the garage door reaches the fully closed position, but then immediately reverses and opens again automatically. Before this operation, I manually closed the door.

Need install the double garage door motor, the new motor is ready.

Single Garge Door. Cables came off pulley wheels when ladder caused obstruction. Setting nuts released to untangle cables and allow door to shut. Cable on one side has some kinks. So need cables replacing and tension coil reset.

$50 to quote the job (not the cost to build it). Looking for an experienced garage door fabricator and installer. Double door width. Perspex sheet light windows. Replacing a window with the garage door. This area was a garage before. Photo attached of rough measurements and style. Beams can be metal or timber.

The garage is not working at the moment. The remote is unabke to control door.

Scope of Works: 1. Provide temporary propping to the existing roof structure 2. Careful removal of existing roller door attached 3. Careful removal of existing brick work, door jam and architrave 4. Supply and install timber lintel and frame work to support gable end of roof load 5. Install new door jamb and architraves for nice finishes 6. Remove and dispose of all associated rubbish on site Structural engineer's design is required

My garage door can close by itself after 3 min open. Also i need reprogram new remote - see photo The motor : GDS 800

Garage door motor needs either fixing or replacement

I would like a garage door servicing

Garage door needs fixing. One of the springs is broken and needs replacing.

My electric garage door frame was damaged when the rear-view mirror of my car hit it while reversing. The garage door is still working normally, but the frame looks dented. I’m hoping to have someone repair the damaged part of the door frame and repaint it so it looks new again.

I am after quotes for the supply and installation of garage door opener system for an aluminium roll-up garage door. Size app. 2.7 m in width and 2.6 in height

One flush mount panel door W4000xH2400; one roller door W1600xH2400

Car backed into garage door whilst the door was going up. Slight bent on the garage door, need to straighten, or reasonably straighten. Garage door working fine, just fix aesthetics.