Hire a professional washing machine repair service in South West Sydney

Fisher & Paykel - Error message displayed is E7:09.

Fix washing machine. It’s like the water isn’t draining, maybe blocked? It washes for a few minutes then gives an error sign until I unscrew the cap and let the water drain out from there. Machine is about 5 years old. Price is at $10 because I’d like to see your quotes. Thank you!

pe error on LG washing machine

Hi, My dish washer is not working properly. The water does not splash or circulate during the wash cycle, and the water inside does not drain through the filter. The water stays stuck inside the machine. I will attach photos to show the issue. I’m looking for someone experienced with washing machine repairs who can: • Inspect the problem • Fix the drainage / water flow issue if possible Please let me know: • Your experience with washing machine repairs • Availability • Estimated cost (if possible) Thank you!

it's from the brand haier, it floods my laundry room everytime we start it

Repair of spring to prevent banging sound when wash mode is used.

Rubber has mould build up on current washing machine & need to replace the seal

Fix faulty display panel of lg washing machine

My washing machine works well but stops in the cycle of draining the water. I’ve checked the filters and they all seem to be in good order.

Washing machine works well but can’t not drain the water therefore it stops half way into the cycle

We had a tear in the diaphragm seal ; Samsung machine; and my flatmate had a handy friend who had a go at replacing it once we acquired the part.. they were unsuccessful And now the washing machine is in pieces - can’t quite get the second wire/spring back in place, so it has been dismantled and left the parts. The pictures are of the machine and seal part details.

I’ve just gotten a new washing machine, it’s in place but needs to be installed. Please tell me your relevant qualifications

OE error washing machine - not draining

The water pipe in the washing machine needs to be changed as it’s leaking we have a new pipe

I need a new rubber gasket for a Haier washing machine model HWF80ANB1

From last night the connection is dead in my washing machine.

I need a licensed plumber to relocate the washing machine tap (on the right-hand side) so it sits under bench height (approx. 500mm lower than current position). This is so the washing machine can be connected from below the bench. Please, if possible, separately quote the cost to also relocate the sink tap on the left. This would allow installation of an above-bench tap (bench-mounted, not wall-mounted) in the future.

I need to put the rubber on my washing machine back on. I removed it to clean it thinking it would be easy to reinstall, but I can't put the metal rings back on.

I am replacing my washing machine tomorrow and the cold water tap is leaking after I removed the old machines water inlet hose. The tap on the left is hot water and has been blanked off (due to the same issue). The tap on the right is cold and is currently dripping/leaking even though the tap is turned off. Looks like the rubber/plastic washer inside the tap has disintegrated. Need the washer and jumper valve/seat replaced/reseated. For reference, the second photo shows the washing machine inlet hose when it was connected.

Hi I need someone to set my washing machine please