Hire a trusted car oil and filter change professional in Georgia

I have a Oil pan gasket leak

just need ignition coils replace

I just bought the bike and I want to make sure the oil change is up to date also I need some one to take a look at my shifter ,I’m having trouble getting it on neutral and I feel that something needs to be adjusted

2016 Nissan Pathfinder, oil pressure sensor code P0520. New Sensor. Scan tool reads 5.11V and multimeter reads 0V harness sensor when signal wire is jump to ground. this poinst to a broken signal wire. Need some one to find break in signal wire and repair

Need to remove lower intake manifold

1. The "Open Circuit" Voltage (The 5.11V Mystery) Most modern Nissans use a "Pull-Up" resistor inside the ECM. How it works: The ECM sends a tiny "reference" voltage (around 5.1V) down the signal wire. When the sensor is plugged in and working, it "pulls" that voltage down to a lower level (like 0.5V at idle or 4V at high pressure). When the wire is broken: The circuit is "Open." Because there is no sensor at the other end to pull that voltage down, the ECM sees its own internal reference maxed out. The Result: The scanner shows 5.11V because that is the maximum "ceiling" of the internal circuit. Diagnosis: If you have 0V at the sensor plug but 5.11V on the scanner, the wire is physically snapped between the ECM and the plug.

Ford escape 2013 I have a coolant leak Have one week to complete this for me Oil leak Cv bolts are popping and rotors and breaks need to be redone n replaced

Replace the oil pressure sensor

The inside of my car said I need to change timing belt

Replace oil control valve

Just need oil change I've got the oil and filter just no jack

Time chain belt needs replacing

I noticed oil dripping near exhaust pipe

I need an oil change for my 350z Nissan

Battery is dead need to get checked before riding .

Oil change for 2011 Nissan Murano

Get my clock working again by oiling it to make it run