Find a local Tasker to inspect your Ford in Los Angeles

I already have the new oxygen sensor I just need somebody to take out the old one and put in the new one.

I have the supply line and the gaskets and the coolant leak a lot so I need to blowout some coolant in and around the sparkplugs. I have already removed the intake manifold and have stored the ignition coils and fuel injectors. Everything is inventoried. I have been working on cars since high school. I'm 55 years old. I just have a bad back, and this engine well is not very roomy. So I need a wrench I don't own and patience I have run out of.

Need an aftermarket Clifford car alarm deinstalled from a 2001 Honda CRV. It turned itself on after the battery died and we recharged it. We don't have the fob anymore. Can't turn the alarm off now and it has an ignition cut off feature, so we can no longer start the car.

I’m currently facing some financial hardships and would really appreciate any help or flexibility on pricing. . My 2007 Ford Fusion’s wheel bolts were over-tightened during a previous tire change, and now three of the bolts are stuck and can’t be loosened. I need these bolts repaired and a new tire installed.

2012 Ford F150 timing chain replacement

I scanned my 2018 Ford mustang Ecoboost and two codes came up can anyone help me figure out what could be the issue , It is misfiring terribly and different smells have been coming out of the car ! Check engine light is on and the car is not drive able . If anyone can figure out what parts need to be replaced we can schedule another date for the car to be fixed once all parts arrive !

2016 Ford fusion alternator replacement，i have part

Replace a head gasket on v6 engine ford explorer 2017

Car is idling rough and jerking. Engine is loud and struggles to accelerate at low speeds. Gas is running out quicker than usual.

install a complete aftermarket sound system in my 2-door Ford Bronco. I have already installed the speakers. All equipment is already purchased (Alpine amplifiers, Alpine 8″ subwoofer, wiring kit, distribution block, fuses, speaker wire). Picture is in attachment to confirm if any additional part(s) is required. I need clean, professional installation. ⸻ Equipment to Be Installed: • Subwoofer: Alpine R2-W8D2 (8″, Dual 2Ω) • Amps: • Alpine R2-A75M (Mono Amp for Sub) • Alpine R2-A60F (4-Channel Amp for Speakers) • Wiring Kit: NVX XAPK1D 1/0 OFC Dual Amp Kit • Additional accessories: RCAs, speaker wire rolls, subwoofer enclosure, fuses, distribution block ⸻ Scope of Work: • Remove necessary trim/panels carefully • Run 1/0 power wire from battery through firewall to cargo area • Install distribution block and wire both amps (4-ga branch lines) • Connect amps to subwoofer and Alpine speakers • Properly ground all components (chassis prep if needed) • Mount amplifiers securely in cargo area and rear side panel • Tune amps (set gains, crossover frequencies: HPF for speakers, LPF for sub) • Test system for clean output, no noise, safe operation • Reinstall panels neatly, minimal rattles

Install upgrade for car infotainment system.

Just need a basic tune and timing on the 302 in my 1965 mustang

Gasket blown out need to replace

Go to California and pick up the dash 2006 Ford F250 Truck Dash Basil plastic and bring it to Las Vegas four hours and 10 minute drive without stopping

Cigarette burn in pasanger car seat for ford exporer

I purchased a gps/backup camera that I need installed on my 2011 ford fiesta ses

I’ve had this Ford F1 119 82 for over five years. It’s been running great. But all of a sudden it’s having trouble turning over and it will turn over a little bit but then when I try to crank it, it goes slower and slower until eventually doesn’t doesn’t get the gas at all. Would love a diagnosis so I can drive it.

I have a Rough Country 3 inch Lift Kit for my 2015 Ford F-150, it is a pretty simple kit, but i never done it before so need some assistance, I have ALL the nessacery tools.

Cannot open hood on truck

My pcm has to be rebuilt for my ford expoler. 2004