Find experienced local auto electricians in California

If you need a bigger budget lmk. I dont know how long the task will take but ill be fair. I need help finishing the wiring on two lighting items on my 1996 Toyota 4Runner. 1. LED Aftermarket headlights are already installed and the low beams are working. However, the high beam and halo lights still need to be wired, i have the wiring harness but im not well versed on these matters, and would rather not ruin it. It just needs to be properly connected so the high beams and halo rings function correctly. 2. Light Bar(On the roof rack) The light bar is already mounted on the roof rack, but the wiring has not been completed. The wire is just hanging down the side and is not long enough to reach the battery, so it will need to be extended and routed properly (id like to include the parts for wiring in this my budget/offer, so you can buy what you know works best) Ideally id like the wiring to be (sort of): Run the wire cleanly to the engine bay, Install a relay and inline fuse(included in budget) Connect power to the battery Run the wire (switch) through a grommet (there's supposed to be one near the brake booster) into the cabin Install a switch inside the vehicle to control the light bar I'm okay with solder or crimp connectors, whichever you normally use, as long as its good. Notes: 1996 Toyota 4Runner (3rd gen) Headlights already installed Light bar already mounted May require some extra wire, connectors, and a switch (include in budget or make an offer and I'll can increase the price) Looking for someone comfortable with automotive wiring.

FitCamX dash cam front and rear 2024 Mach E

Driver side light bulb on headlight doesn’t work need replacement

The air in one of the tyres of my electric scooter doesn’t seem to be filled properly.

Car starter replaced on 2000 Buick Century.

2011 Chevy volt cv axle replacement on front driver side

Starts but will not idle, check engine light stays on. Was running great, had to change timing to pass smog

Hello. I have a 2017 Range Rover Evoque. The fan wouldn't shut off yesterday. This morning the fan was off and I believe the battery is completely dead. Can't open the doors.

tensioner pulley, alternator, and serpentine belt change on a Honda accord 2018 sport 1.5. I have all the parts I’m just looking for someone who can put it on

Need 2 breakaway bolts removed from my 2010 Nissan 370z Electronic Steering Lock Actuator. Easy access, bottom panel already removed. That's all!

Remove Electronic Steering Lock (2 breakaway bolts)and replace with new one for 2010 370Z Nissan. Easy access to ESL since i removed bottom of dash board already. Also need Keyfobs to be programmed afterwards if you have set up. If not, not a deal breaker. 1 hour job max.

Starter on my Audi Q7 truck went out needs to be replaced

I need my Steering Wheel Lock unit removed, drill small holes on top of the unit, then insert small screw through both holes,which will keep locking mechanism pressed down permanently, then re-install unit. Both Keyfobs has new batteries and car battery is fully charged. Car parked in my garage.

change 3 ignition coils on infiniti QX 50 2017. ALREADY PURCHASED THE COILS.JUST NEED REMOVE THE OLD AND INSTALL THE NEW. NO OTHER PROBLEMS.

Old Alternator removed and new one put in .

Need my old alternator out and new alternator in asap .

I need an electric starter solenoid replaced and rewired on my dewalt pressure washer!!!

I need to install these led lights into my challenger

2003 chevy s10 , crank no start , scanner doesnt read ignition being on, started happening after fuse was replaced with higher amperage causing it to blow and fuel pump replacement. Has had a parasitic drain for years as well

My 2018 Camry wont start. There's electricity, but won't start. Maybe it's the starter. Need a mobile mechanic to repair it.