Find trusted appliance installation services in California

Looking for someone to set up my kangen machine and 4 stage pre filter

I have a talaria x3 and i need the swing arm taken off because i dont have the part and i need a chain drive installed i just bought

Hi there. Reaching out on Thumbtack to see if there are any Marines or local handyman who can install a simple oven igniter on a GE wall oven? My friend says she thinks its a simple project? Thank you (I will buy the part)

Jzones (model V630) dashcam installation - hardwired to fusebox (space 36, I think) - this was a Xmax gift that I was going to DIY and connect to one of my 3 12v receptacles but I found that all are hot and are not connected to the ignition. If I use one of these, I will surely drain my battery. I suspect I need to hardwire using a fuse tap. I can order the hardwire kit online if need be; however the online kit looks to include a lot of unnecessary wires. I would like an estimate...........thank you

just install new microwave oven

We purchased the eufy PoE NVR Security System S4 Max + 4 PoE Cam S4 Add-On. We will need installation of three cameras on a solar parking area and five on the building. We are seeking hard wiring of the cameras.

Pedal assist sensor installed display stuck on 3 wiring needs fixing headlight needs fixing

Hello, I would to uninstall my cable machine brand body solid GT100

We have a wash dryer that needs to be installed next to an existing washer, so likely we'll need to split the water line in some way. Bidet needs to be installed pretty simple but ideally we'd run power to it so it needs to be neatly wired. Bunch of cardboard boxes need to be torn apart and removed

Need the impeller to be reinstalled on a kenmore top loader washing machine. Our washing machine would shake and came to the conclusion that the suspension rods needed to be replaced. While my father in law was looking to replace them (not sure if he did) he decided that the basket was too loose and attempted to remove the impeller, in his attempt he managed to get it somewhat out but was unable to do so... the bad thing is that now we're also unable to put it back in its place. I need someone to remove it and put it back in its proper place. Need someone with experience because the impeller seems to be made out of plastic and brute force may just cause it to break...

Install a hood in a new remodeled kitchen

Replace air filters for heat and air conditioning

I purchased a 6 camera setup through eufy that I need installed. I currently have an old-school CCTV system install that is all wired to an NVR in my closet. I'd like to replace all of the existing cameras (and wiring) to the new eufy system. All new cameras will be in the same space as the current cameras.

Hang exterior Christmas lights and then take down after Bew Years.

Need to install new dishwasher

Need rock lights installed in 2024 Jeep Wrangler 4xe, and hard wired to the aux inside. I have interior lights already installed but on an external button, and if there was an easy way to get them installed via the aux too, that would be great.

Simple Carplay installation for 2015 Macan S. (Simple Model just for Macan S)

I need a licensed electrician to install 4 bromic electric patio heaters. 2 are 4000w and 2 are 3000w. I also need 1 channel dimmer and 2 channel on/of switch installed.

We have all the lights It’s a 2 story home and you will need an extension ladder that reaches to the front eaves Attached photo shows what we did last year

We can help lift so no need to hire assistant to help lift range. It is advertised as ultralight weight for small kitchen. Home Depot says task can be done in less than 1 hour. Must have experience installing range hood. Can add on other work. Thank you.