Find professional pool maintenance in VIC

Swimming pool pump and filter system repaire one of vault has broken. Need replace

Showing error 5 and error 2, too hot but water is actually cold

Looking for someone who may be able to assist with repairing a Japanese Head Spa unit in Cowes, Phillip Island. The unit appears to have developed an airlock and is no longer pumping water through the halo/ring system. The pumps are running, however there is no water flow and it likely requires priming or troubleshooting. 📍 Cowes, Phillip Island 💰 Happy to pay for your time and expertise If you have experience with head spa units, pumps, plumbing systems, spa equipment, or similar machinery, please send me a message. Thank you 🙏

Swim spa covers starting to come away from stitching and needs repairs

Seeking a qualified pool technician to inspect and fix a leak in a small plunge pool. Plumbers and a pool shop suspect a worn-out spider gasket in the multiport valve, or a faulty hydrostatic valve at the bottom. I need a proper diagnosis before replacing any parts. Scope of Work: • Leak Detection: Run a pressure or dye test to find the exact leak location. • Minor Repair: If it is the spider gasket on the Hayward filter, replace it during the visit. • Report: Provide a clear assessment if the issue requires major structural or underground repair. Budget & Cost Details: • My $200 Fixed Offer: Covers the call-out fee, diagnostic testing, and repair labor. • Parts Cost: Excluded from the $200. I will pay for any required parts (like a new gasket) on top of the labor upon presentation of a receipt. Requirements: • Experienced pool technician. • Must bring professional leak detection equipment. Location: Kew, VIC Timing: ASAP. Please state your experience when bidding.

Last time I used the spa I could see smoke coming from the pump.

✨ Head Spa Repair Needed ASAP ✨ Looking for someone experienced with plumbing/pumps/electrical systems to inspect and repair a Japanese Head Spa unit located in Cowes. The “halo” water ring has stopped working after transporting the unit. This has happened once before and was caused by an airlock, however I’m currently interstate and unable to troubleshoot or inspect it myself. Details: • Non-plumbed portable Head Spa unit • Runs from a clean water tank + separate dirty water tank • Contains 2 separate pumps + control panels underneath the unit • Power is working, issue appears to be with water flow/halo system Would ideally need someone who is confident with pumps, tubing, water systems or spa/salon equipment. 📍 Located in Cowes 🚗 Unit would need to be picked up and returned ⏰ Needing assistance ASAP Please message me if you can help or know someone who may be suitable

to replace or repair the spa trap /waste pipe on the second level and stop drain letting out water.

We have a spa at our rental property that isn’t in action. We want to service it and get it working

Basically, we have 2 ponds that feed into each other via a water feature, however one of them (possibly both) have holes in the lining so constantly lose the water. Was looking to get the pond relined so we can keep it filled up and reintroduce some fish to the water. The pond with the definite lining issue is the L shaped one. All equipment works as required. The L shape pond feeds water into the water feature, which then moves to the rock pond, which is connected to the L shape via pipe. Ill update the price once we agree to a final price and job details.

Spa stopped working after power surge. Appears to be damaged C-Bus relay/power supply.

Garden water feature pump installation + electrical connection. The pond has been fully drained and cleaned (see photos). A new pump has already been purchased. Tasks required: - Install and connect the new pump - Set up safe outdoor waterproof electrical connection - Test system and ensure proper operation Easy access on site. Ready to be done anytime. Budget is flexible for the right person.

Outdoor spa power cord burnt out needing it replaced

I need a professional to remove this pond pump & supply & install a new one. Job is in Essendon.

Our Davies spa seems to have error faults and we can't clear them

Pool heat pump + VS pump installation (existing plumbing – simple swap job) I am looking for an experienced pool equipment installer or licensed pool plumber to install a pool heat pump and variable speed pump. Ideally someone who has done multiple heat pump installs before. Scope of work: • Supply and install (or install only) 20kW inverter pool heat pump (likely SensaHeat ES or similar) • Install Madimack InverFLOW 400Plus VS pump • Fit check valve • Seal 3 spa jet penetrations • Connect into existing plumbing (replacing gas heater + solar heating system) • Electrical connection to existing circuit (or quote separately if electrician required) • Commission system and confirm correct flow rates Pool details: • 7m × 3m outdoor pool (~32m³) • Existing equipment pad • Existing heater plumbing available • Single phase power • Located Hawthorn East Important: Looking for someone experienced with pool heat pump installs (not general handyman work). Please include: • Your experience with similar installs • Whether you are licensed (plumbing/electrical as applicable) • Availability (ideally within 2–6 weeks) • Whether you can supply unit or install customer supplied • Total price estimate Photos of equipment area available on request. Thanks.

our glass pool door should close when its not being held open however, at the moment it's not shutting properly. this is a safety hazard. the issue is with alignment perhaps. magnet strip also needs replacing

I’m experiencing a suction-side air leak in my pool system and need a qualified, insured pool technician to diagnose and fix it. Symptoms: Suction pool cleaner (Zodiac ZX8) running very slowly Air bubbles visible in the pump basket Skimmer has water but drains quickly and draws air when suction is applied Skimmer line can be isolated at the 3-way valve; Likely causes include a skimmer line air leak or a faulty 3-way valve O-ring/diverter. Requirements: Qualified and experienced pool technician Fully insured (public liability) Experience with suction-side plumbing and skimmers Please briefly describe: 1. How you would diagnose a suction-side air leak (e.g. skimmer line vs 3-way valve vs pump lid). 2. Your experience with skimmer line issues and 3-way valve O-rings/diverters. 3. Confirmation that you are qualified and fully insured for pool plumbing work.

Hi there, We are not looking for regular maintenance services, so if this is what you are looking for I am sorry to disappoint you. As much as I want to support you as a small business, it is also quite pricey to pay a few hundred everytime for us. What we are looking for is someone who is experienced to look at our system as a whole and tell us what is wrong with the pump / anything we need to do in particular. Currently, the pump is blowing bubbles (it used to be very strong pump, but we can see that it is also not sucking the water very well). We suspect that there is a Air leaking somewhere, or blockage. We have tried back wash, adding water, adding salt, everything available suggested online. We also regularly test the water at the pool shop. Thank you for your time.

Need pool filter replaced. I have everything needed just a simple swap of equipment