Find an experienced plumber in Darwin City

🛠️ Remove Freestanding Hand Wash Basin (Already Disconnected) – Darwin CBD Description: I need a careful and reliable handyman to remove a freestanding commercial hand wash basin from my office in Darwin CBD (Cavenagh Street). ⚠️ The plumber has disconnected all water supply and pipework, so this job is removal only (no plumbing required). About the unit: • Freestanding cabinet-style basin • Stainless steel sink with white metal cabinet • Already disconnected from water and waste • In good condition – I plan to sell it second-hand, so it must be removed carefully without damage Scope of work: • Detach the unit from any wall and/or floor fixings • Carefully move the basin out of position • Place it safely on the other side of the office • Avoid damage to: o The basin unit o Surrounding walls/tiles/floor Tools & requirements: • Bring your own tools (likely screwdriver/drill/spanners) • Experience removing cabinetry or fixtures preferred Location: Cavenagh Street, Darwin CBD Timing: I am flexible on timing. I also available in the evenings and at weekends if that is easier. Budget: $200.00

Description: I need a licensed plumber to safely disconnect the water supply to a commercial hand wash basin located in an office in Darwin CBD (Cavenagh Street). This is a freestanding, cabinet-style stainless steel hand basin with: - Hot and cold water supplied via copper pipes from the wall - Standard PVC waste pipe/trap underneath Scope of work: - Isolate and shut off water supply - Disconnect hot and cold water lines from the basin - Cap or seal pipework safely (so water can be turned back on without leaks) - Ensure everything is left safe and compliant Important: - The basin will be removed separately after disconnection, so no need to remove the unit itself - Must be done cleanly and carefully to avoid damage, as I plan to sell the basin second-hand - Please bring your own tools and fittings (caps, etc.) Requirements: - Must be a licensed plumber (NT) - Experience with commercial or similar installations preferred Location: Cavenagh Street, Darwin CBD Timing: Ideally within the next 10 days (ie. before Saturday May 23). Budget: $150-$250

Shower water stop needs replacing , I need an expert that’s knows how to do this

We need a leaking tap fixed or replaced. Refer the image and let me know what you think is necessary. It’s leaking from where the tap meets the basin. There is parking at premises 2.4m high underground parking.

The shower is working, but The diverter button that should send water to the bathtub is not functioning, and I have been advised that the specific part is not available, so a full diverter system replacement may be required. Because of this, I am expecting that the scope of work might include: Replacement of the diverter/mixer system for the shower/bath Any necessary tile removal and patch tiling Waterproofing in the affected area Making the bathroom fully functional and compliant again As I do not yet have access to the property, I completely understand that you cannot give a fixed quote at this stage. However, it would be extremely helpful if you could provide a rough cost estimate or price range including: Labour Materials/parts Any typical allowances for tiling and waterproofing

Hi folks, I am looking for a Handyman / Plumber to Repair or Replace the following two components of a shower. I have attached several photographs of the shower so that you can better visualise the issue. COMPONENT CIRCLED IN BLUE (IN THE ATTACHED PHOTOGRAPHS) The shower head holder or shower head bracket. (It's the part that cradles the handheld shower head itself). ISSUE: This component is not locking in place at all. It rotates 360 degrees freely, meaning the shower head is not able to be held firmly in place when showering. COMPONENT CIRCLED IN RED (IN THE ATTACHED PHOTOGRAPHS) The adjustment knob or tightening knob for the slider. (You twist this to loosen or tighten the entire bracket, allowing you to slide it up and down the vertical bar). ISSUE: This component will not untighten at all. Meaning it cannot be moved up or down the vertical bar. It is as if it is glued to the bar. I will be at the property late in the afternoon on Tuesday, Wednesday & Thursday this week (October 28, 29 & 30). Ideally, if somebody could visit on one of these days and times that would be great. If you have any questions, feel free to contact me. Kind Regards, Gary

Water is leaking from my tap...happy to pay $100

Change kitchen sink tap. Like for like replacement

Leaking tap in sink. Thank you.

Replace rusted gal water pipes in factory

I need to fix under the sink water filter system and for that i need to drill on the slab

Hi Chris, Need old fridge asked for repair ! I just thought it needed regasing but not sure!

My friend whos not a plumber tried to set a water filter under my sink. Now theres a water leakage and my dishwasher stopped working as well. - Due date: Needs to be done on Tuesday, 27 June 2023

Plumber to install fridge tap.

bhbhbhbhbhbhbhbhbhbhbhbhbhb - Due date: Needs to be done on Friday, 25 November 2022

Need some pipe work installed, putting a bathroom downstairs of a raised house No cutting or digging of concrete required