Find a trusted local mechanic in Ipswich

Yamaha 60hp been sitting 6 months would like to get running again would need service new battery

My car is a holden hatchback barina 2017 and the oil percentage is at 0% currently im a little bit worried on whether i can drice the car or not and i also only have $100 to spend on the oil change, urgently aswell is that possible. Or can you guys do a pay half and pay rest later if thats possible. If it goes over 100

Hi need full brake pads and rotors front and back for prado 120 2005 v6 grande model. Needed as soon as possible as i suspect my brakes are extremely worn. I can supply bendix brakes or you can quote me for the full job please, preferably today if possible anytime. Located in redbank.

Would need to get a quote in person to fully diagnose the issues Mechanical problems occurring: - rear brake pads need changing - wheel bearing may need to be looked at on front wheels Happy to buy the parts after it’s been looked at

I bought a car from a licensed dealer. But the car is faulty with engine light on. And currently stopped working. It does start and runs, but does not go above 25 KM/Hr. So I reported the dealer to Office of Fair Trading. They asked me to get detailed car inspection as we may have to present it in the court against the dealer.

supply and install or just install and I will buy the head unit and reverse camera. Please provide quote for both supply and install or install only. Thanks

I have a light bar to be installed (number plate mount). I have all wiring harness as well.

Looking to purchase a second hand vehicle, need a qualified mechanic to give it a once over and advise if there are any major issues before purchasing

Hello Clutch is working but it is not holding the car on a hill Probably needs to be replaced on a Nissan xtrail Thanks

In photos is a quote for the fitment of a brand new Ironman bullbar with $659.10 worth in labour at a workshop. I will not accept offers over $700 I have purchased a second hand ARB commercial bullbar and looking for someone with the time and know how to fit it for me. Vehicle is a 2011 Mazda BT50 it has previously had a bullbar installed so shouldn’t be too hard

Have two vehicles each needing a light bar installed. Have light bars and wiring harnesses

Need help installing oil feed line in Hyundai i30N

Need light bar 40 inch slime line installed on my roof rack today! Have all the wiring and bits and bolts

Need a CO2 sensor replaced on Mazda 3 2009. Have the part ready to go

job started but were stuck at the balljoint the car I'm a 2003 sunaru impreza wagon, manual. located in goodna

I put the wrong oil and then it show my car is overheating so I’ve top up the water cooling system and that’s fine but I checked the oil it’s different colour

Ve Holden replacement of front struts and lower control arms. All parts are supplied and new.

Installation of Alpine Head Unit into 2018 Japanese Import Toyota Hiace. My partner started the install mostly connected but there’s a few plugs he’s not sure what they’re for. No reverse camera to fit, already installed.

I would like to get my car’s break-pads replaced. Vehicle - Honda Civic 2008 I will provide the breakpads

2007 Dodge Caliber Diesel No indication of any clutch problem previously. Went to start car and the clutch pedal was stuck to floor, no pressure. Im needing to know what is wrong with it so I can get the right parts or decide not to fix.